Rated 3.1 out of 5 by 13
Rated 3.0 out of 5.0 by jmarina Works but wears down fast
I used this to cut a metal bar stool in half. It did the job, but by the time I finished the wheel diameter went from 3inches down to 1 or so (barely past the tool depth). It worked, but you'll go through a lot of them if you have a medium or large sized project
April 11, 2016
Rated 5.0 out of 5.0 by Vog8 Worked perfect
Worked perfect, we were cutting off metal spindles for a handrail and these did the job with no problem.
December 8, 2015
Rated 1.0 out of 5.0 by wagedu Quickly worn out
I gave it a try to cut really thin steel plate into 3 ft. strips and it disappeared in less than two strips! Not even 5 feet and it's a gauge 28 sheet. I mean, it's such a thin plate that it's hard to find one.
To finish cutting the second plate I had to bend it, and then finish it... with a Dremel rotary tool, whose cutting disk handled the job much better!
So, the saw disk is worn out with the same plate that the rotary tool disk can cut without problems?!
it's a disaster
May 14, 2016
Rated 1.0 out of 5.0 by ATG7 A failure with metal...
This "saw" came with my tool, and I used it for cutting plastic pipe with ease. But, when I used it for cutting simple, thin-gauge garage door opener angle iron, well, with even propping up the metal well, the saw shattered and it could not handle the metal. Sadly, this was one of the reasons why I got this tool...to cut simple, thin metal. I am not a tool or handyman "novice"...so I know how to use tools. Sadly, this one blade, when I counted on it for metal (as mentioned on it) missed the mark.
November 27, 2015
Rated 2.0 out of 5.0 by south river I like the saw, but not for metal
The saw is small and very useful. But the metal blade wore out after only a few cuts on aluminum. Great idea, poor execution
December 14, 2015
Rated 5.0 out of 5.0 by jmac galvanized roofing tin was no problem
this cut off wheel did as it should cut right through galvanized roofing tin. myself being the impatient type put three sheets together and was cutting through those at that point the wheel deteriorated pretty rapidly but that is to be expected. if you take your time cut one sheet as you should this thing works wonderful. With that being said as a side note it did cut through 3 with no problem
April 7, 2015
Rated 5.0 out of 5.0 by Tuff Time Saver
The picture show the roof on the gazebo that I used my dremle saw to cut the roofing material and the wall is 70 ft. of dog-earred wood panels.
October 14, 2014
Rated 3.0 out of 5.0 by Fnggrant Not for all metal
I got this to see if I could cut a tire in half. It did cut through but metal in the tire ground the wheel down. Im glad 3 came in the pack. I just don't recommend using it for that purpose.
September 16, 2014