Rated 4.2 out of 5 by 22
Rated 5.0 out of 5.0 by Prickamongus Good Investment!
I have only used it once but it did a nice job and was convenient to use. A lot more rugged than the thin sanding/cut-ff discs. Good design.
October 4, 2016
Rated 5.0 out of 5.0 by tony Dremel ez lock metal mandrel starter kit
Easy-to-use cut metal very good,for what
I need it was perfect
October 25, 2016
Rated 4.0 out of 5.0 by JB Worked well
Worked well and was very convenient. Drawback is the cost of all new cutting wheels because once you have this one on it is a pain to take it off to put the other one on.
October 17, 2016
Rated 4.0 out of 5.0 by CJ Worked
This product works great. And is very easy to operate and set up. Disk are strong and don't brake as easy as some others.
October 5, 2016
Rated 4.0 out of 5.0 by Bowcowboy Get's the job done
The ez lock took a second to figure out but after that it is a breeze . The cut off wheel works great .
March 10, 2015
Rated 1.0 out of 5.0 by Clark Mandrel is not very durable.
I used the EZ Lock diamond wheel with the mandrel from this kit to attempt to cut a 6" diameter hole in 3/8" porcelain tile. I had water running on the cut as it was occurring to lubricate and cool. The shoulders on the Mandrel chipped off after cutting half the hole. When the shoulders are chipped off, the wheels that is installed will fly off off the mandrel when ever and lateral torque is applied.
February 23, 2016
Rated 5.0 out of 5.0 by wingnut Dremel cut of wheel
I was very pleased to see that dremel followed the rylok method of attaching a larger cut of wheel. It made my latest task so much faster not having to change wheels so often and how strong they are is great.
February 23, 2016
Rated 4.0 out of 5.0 by 2Acre fast change
I decided to finally switch over to the EZ Lock system. I just ran out of the older cutting wheels. I put these in the Dremel, and away I went! I'm probably a little more aggressive when it come to cutting. With the old style cutting wheels, I would have gone through about 10-15 of them for the job I just finished. These cutting wheels, I'm on my third one and the job is done! It was 50 cuts through stainless steel in 90 minutes each 6" long. That includes fitting each piece. There were a couple of pieces that were just too big by the width of the wheel. I went through the stainless steel taking off just the width of the cutting wheel.
These cutting wheels last longer, cut faster, and are easier to change.
October 31, 2015