Rated 1.8 out of 5 by 13
Rated 3.0 out of 5.0 by PapaRoss Good idea
Product is a great idea. I hate using coping saw to cope trim for a neat corner fit but used the spiral blade on this. It does cut but also does burn as others have noted. Very slow cutting. Must set tool at high speed. Be careful when inserting or removing blades to keep from breaking spring loaded forks.
October 29, 2012
Rated 1.0 out of 5.0 by Td644 Broke apart after using it a few times
Bought this a while ago to cut a difficult pipe, worked pretty good, although it was tough to put on. Tried to use it to do a coping cut on crown moulding and it broke. poorly made. Would not recommend.
April 22, 2014
Rated 1.0 out of 5.0 by DisappointedSMH Does not work with Mm40
Extremely disappointed! Is there multi-flex tool that actually works with the mm40??
January 12, 2014
Rated 3.0 out of 5.0 by nickfire mm45
I bought the same attachment and it does not fit the MM45
December 22, 2013
Rated 1.0 out of 5.0 by Mark Uh
See ANYTHING in the description that says this won't work with the Dremel Multi-Max MM45? Yeah, neither do I.
December 10, 2013
Rated 1.0 out of 5.0 by NicknameisAB very bad product
Could not get half way through first project before blade went flying across room. Check instructions installed a new blade and after I turned it on it too went flying across room. found one blade I hope the other does not end up in my car tire. I am going to return to Home Depot hope there will be no problem. our customer service is lacking over all compared to other Home Depot customer service depts.
October 12, 2014
Rated 1.0 out of 5.0 by badknee Broke into two pieces first time
I build things every day, and for x mas I recieved the ridgid multimax multi tool. When I saw the multi flex I thought aw, maybe this tool will be handy. I used it one time to help a buddy cope cut trim. I was not even cutting just tighting the tool to the ridgid when half broke off. Very poor design, the two side pieces are have attached to a ring in the middle which is where it broke off. JUNK>>>> not worth thirty dollars and am sure a lot of people will be disappointed as I am.
January 10, 2012
Rated 2.0 out of 5.0 by Wjmp Junk--broke while attaching it to the tool
This yoke could be a great attachment if it were made of stronger material. It broke under light pressure while mounting it to the dremel head. Not worth it.
June 17, 2012