Rated 4.1 out of 5 by 26
Rated 2.0 out of 5.0 by LiftedGMC Not impressed
I received this kit and what was sent to me was the same kit except the horizontal end cap, it was just a tube with wire in the middle. I didn't receive what was in the description nor the picture. Home Depot customer service was very good to help me out. After installation I started the pellet stove and the 90 degree elbow leaked through the factory seems!!! I was not happy at all, after some research on the internet I found that this is a common problem with the 90's so I called customer service once again and they did help me to my satisfaction. But over all the product wasn't what I expected at all. I am not knocking Home Depot just the dura vent product wasn't up to par!
October 18, 2016
Rated 5.0 out of 5.0 by RebateRage Easy Installation
We had received an estimate from a local stove installer and the cost of materials only came to over $600. We found this kit, ordered it online, it was delivered to our door and after cutting the hole in the wall had it installed within an hour. It was really very easy to install. We have been using it for a couple months now without any issues. We did wrap the pipe with heat tape just to make sure we didn't have any leaks but that was probably not necessary. We really liked the black wall cap that came with it. It gives it a nice clean look. We will be purchasing this again to replace piping on a different stove we have.
December 8, 2015
Rated 5.0 out of 5.0 by krazykas0410 perfect
everything i needed and cost effective compared to buying individual pieces. Very happy.
August 16, 2016
Rated 4.0 out of 5.0 by PJ Perfect Kit for Installation of a Pellet Stove
The only thing not included was the elbow piece which my installer required. It would make things easier if this kit were sold in any of my Colorado Home Depot stores. The shipping delay from the original kit order, then from the additional elbow, delaying my ability to install. I ended up having to find the elbow from a tractor supply company.
Otherwise, it's pipe, nothing to difficult or fancy about it. It did the job. I've been using my pellet stove for two months now without any issues. I would buy again.
December 24, 2015
Rated 5.0 out of 5.0 by Bill works great
easy to understand, it was a snap to put togethrer
May 9, 2016
Rated 5.0 out of 5.0 by Lew Good buy
I wish this product would be sold in your stores. I could have used it right away. I had to order it online.
April 19, 2016
Rated 3.0 out of 5.0 by daveyj not as easy as advertised.
For $230 this should be perfect and its not. One of the sections would not twist onto any other section, luckily I did not need it, and the 90 degree joint has smoke coming out from the seams and rivets which means its a factory defect.. It's fairly easy to put together, the This Old House video is a great resource, but make sure you put a lot of RTC red caulk at all of the joints and use tape. Once my unit cools down I am going to rtv the heck out of the 90 degree and tape it. Additionally, the attachment to the Englander stove seemed a bit insecure so I recommend a lot of caulk at that connection.
January 4, 2016
Rated 5.0 out of 5.0 by Bill Easy installation, works great
No problem installing the chimney system for my pellet stove. Each fitting is sealed by high temp rope and twist fit. Most difficulty comes with installing the thimble in the wall. Takes some patience and good measuring. The pipes run warm to the touch. Only wish that the straight lengths came in a 10 inch size or a 6 to 12 inch adjustable model. The 3 inch pipe isn't available below 12 inch.
January 19, 2016