Rated 3.1 out of 5 by 7
Rated 1.0 out of 5.0 by J1a8h Awful
Made a mess everywhere and did not make the job any easier!
May 31, 2016
Rated 4.0 out of 5.0 by KGP161 WORKS OK
This will pick up most of the paint chips but not all. The speed of scraping and the angle of the scraper to the surface will make a difference but it is still not a 100% solution. It is still a great device in reducing the mount of chips that fall away. The device is held on to the vac hose by friction and tends to separate as you are working but some duct tape takes car of that problem.
December 8, 2015
Rated 4.0 out of 5.0 by 1dsanderson Works pretty good!
Only thing missing is a carbide blade instead of steel. Would be perfect for pop corn ceiling though.
September 8, 2015
Rated 4.0 out of 5.0 by Mike6094372865478 scrapes it all away
I bought this item to scrape popcorn from a ceiling. (disclaimer: EPA says leave this job to abestos reclamation company in case abestos is present).
PRO: The product is simple but very effective way to scrape product from a flat surface, it is just as effective as a 4 way paint scraper. The difference is the Chip Buddie Dustless Paint Scraper is desgned to be hooked up to a high filtration vac to remove most of the product and dust that you loosen with the scraper.
CON: It is only 2 inches wide.
January 22, 2011
Rated 3.0 out of 5.0 by s186751 works ok
Scrapes well but misses some of the dust and chipping. I used it to scrape a popcorn ceiling and it let about 30% of the dust and chips escape but it was still much better than not having anything. This company should make a larger one for this purpose that attaches to a large shopvac style hose as this one needs an adapter to adapt from the 1 1/4 inch attachment size to my 2 1/2 inch wet/dry vac.
September 7, 2011
Rated 3.0 out of 5.0 by TxRav Not bad but small
I purchased this product a while back to scrape the loose paint off some sills around a few old windows. It did a good job at getting the loose paint, but the old adheared paint was a little more stuborn. The biggest problem I had was getting this product connected to my wet/dry vac. My vac has a 2.5" hose, and this has a 1.25/1.5" hole.
July 26, 2011
Rated 3.0 out of 5.0 by WKinNj Not quite Dustless
Scraping Lead-based paint? Careful with this tool as when the chips start flying about 90% get vacumed and the rest go flying. A lagre improvement over just using a scraper but the tool could be improved if the plastic vacum shroud was closer to the scraper blade.
August 6, 2011