Rated 4.6 out of 5 by 161
Rated 5.0 out of 5.0 by T1vinson loved it
we purchased this product not knowing exactly what we were doing. With some internet surfing we found how to apply this product and what to expect for a finished surface. we are very pleased with the results. we applied to the entire floor plan which was not the original plan.
August 9, 2016
Rated 5.0 out of 5.0 by landman Quality product, make sure you have the right sprayer or roller... otherwise don't write a bad review, it will be you not the product
I have used this product for a number of years and it is consistent in quality. IMPORTANT TIP: use a very high quality sprayer. The average pump sprayer will not deliver a good experience as they will clog up very fast, and the average pump wands drip incessantly even when the trigger is not deployed. May I suggest the Chapin 19249 Extreme dripless 3.5 gallon model. It is of steel construction and designed to spray a high solids product and tolerate solvents. You will have sticker shock, but in the long run this tank will last you a very long time (if you keep it cleaned and cared for). Make sure to clean up with a run through of solvent such as Xylene and a final run through of Mineral Spirits as a final conditioner. -- This product will add a "wet look" to your block, and darken the sheen slightly. See photo for an example of sealed block vs a grey unsealed block sitting on top of the block run. -- Also, this product is a high solids acrylic and will begin to dry fairly fast. Your first application will require more product. Renew applications may be done at 2 or 3 year intervals. -- You may add a thinner such as Xylene to aid in pump dispersion, although do not add more than a quart per two gallons of original material.
July 5, 2016
Rated 4.0 out of 5.0 by DiY9Magiver Performs as expected, good product
I have about 750 square feet and I may have put extra product on the stones. I purchased 15 gallons and applied a sprayed coat back rolled. I soaked the sand with sealer and rolled a coat over the the whole patio. I used about 11 gallons and a major portion went into the sand joints to harden and seal them.
I expected a shiny wet look but it did not come out as I had envisioned. The right side is 3rd coated and the left side is just second coat, I had previously coated most as there is a small extension. This is second use of the product and I would recommend. In Florida the sealer has a shorter life and requires reseal sooner than I would expect.
We had rain and the beading is as expected.
May 17, 2016
Rated 5.0 out of 5.0 by Satisfied123 Great Concrete Sealer for Exposed Aggregate
The concrete sealer was delivered quickly to my home. The instruction were easy to understand. The product was easy to put down. I used a roller with a 3/4" nap. The coverage was a little better than described. I put down 2 coats the concrete looks great. The gloss look is not too extreme. I would describe it as just right. I will definitely re-order this product again when I need to re-seal my patio.
June 7, 2016
Rated 4.0 out of 5.0 by ClearSeal Eagle Gloss Coat
We purchased this product to re-seal our driveway. In previous years we always used a water based sealer. The solvent base was a little cheaper so we decided to try it. It covers well and appears to be working well (it's only a few weeks so it's difficult to say for sure). May go back to water based for ease of cleanup.
May 31, 2016
Rated 5.0 out of 5.0 by NLM Looks Great
Ordered online from Home Depot, delivered in 4 days, 1 Day earlier than promised. It took me about 1 1/2 Hours to cover what is in pic and about 3/8th of the 5 Gallon Bucket. Went on easy Pic is about 3 hours dry, looks great.
Wear gloves and a mask, the initial odor is pretty strong
May 20, 2016
Rated 5.0 out of 5.0 by Buber great product
Rolls easy and looks good and sealed. I added gator grip as per. directions and is no longer slippery and looks great.
August 9, 2016
Rated 5.0 out of 5.0 by tulambin Excellent coverage just roll it on....!!!!
I have done two jobs with this sealer the first one was six year old regular pavers and the other was 1'x1' garden pavers I installed and the results were great. I only got 350 to 400 square feet per 5gal.so here are the details how i achieved my results.
1st pressure wash even if new wait a minimum of 24 hours to dry.
2nd buy the extra large silver rolling pan not plastic at homedepot paint dept. and a 1/2 inch nap or greater roller.
3rd bring a blower to clear pavers of all debris and start rolling. It didn't matter if I went back a second time after the initial coat was dry the same day it still applied evenly and easily. You can do one coat I just filled the pan up and soaked the roller really good and laid it on. cheers
January 12, 2016