Rated 3.6 out of 5 by 115
Rated 1.0 out of 5.0 by kber A Commercial Shelving Unit this is NOT!
Just when you thought you could not buy another disappointing product you end up buying another disappointing product! The side rails are not one long piece as they should be, it is two pieces so you would think there should be some kind if brace to hold the two of them together since the side rails should be strong to hold the unit together and give it a sturdy base but there are not any braces to hold the two pieces together, silly design. When they say you may need a rubber mallet to set the rivets, you actually need two and 4 hands when you tap one side down the other sides pops out. A commercial shelving unit this is not! Would not recommend, spend a little more money and get a better product!
July 1, 2016
Rated 5.0 out of 5.0 by Tmonkey716 Good Product
These shelves are sturdy and look good as well. No issues.
July 19, 2016
Rated 4.0 out of 5.0 by Snoop EASY TO ASSEMBLE
The shelving unit is easy to assemble. No tools are required, However, a rubber mallet is helpful to lock the components in place. If you have a helper, assembly is even quicker. Pressboard shelving is adequate but keep away from moisture. Stable & relatively adjustable.
July 19, 2016
Rated 5.0 out of 5.0 by olddude Solid sturdy storage
I used a mix of 3' & 4' width units (total=7) to fill a basement storage with shelving. Assembly required no tools, but I found a length of 2x4 helpful in locking in the horizontal shelf supports to the vertical posts. The 6' vertical posts are two 3' pieces, so you really have two 3' high units - top & bottom. Getting the vertical posts for the top half locked in was tricky. I used string to suspend the first top posts until I could get the horizontal shelf rails locked in. Then it went pretty easy. Do make sure that the bottom is fully locked in before starting the top. I found the dual locking pins and slots very sturdy and if I had a problem locking one corner, it was because I has miscounted slots at a different corner.
The shelf material is pressboard, which outgasses a bit. Sturdy enough for my use & easily replaced if I need something stronger. Overall I am very happy with them. I have used other wire shelf units with round posts that were just flimsy by comparison. they do NOT have levelers however, or little numbers on each slot.
July 22, 2016
Rated 3.0 out of 5.0 by ApatheticallyRealistic Nothing to write home about
Firstly, I'd like to say the buying experience was great. Purchased online and had it shipped to my local store with no issues.
As for the shelf itself, it's lacking in quality and strength. It went together fairly easy, with no drilling/screwing required, but the metal is extremely thin and poor quality. I'm unsure of how they can boast their current load rating, especially after examining the particle boards used in the shelf frame.
My biggest concern is the metal braces are easily bendable. When I assembled the horizontal beams/supports, they were slightly bowed outward, leaving a 1/16" to 1/8" gap between the support and the shelf board. Given that the perch that the board rests on is a mere 1/2" (or less), this meant that even less of the support perch was actually making contact with the shelf board. I attempted to "straighten" the cross beams/supports, but that placed the rivets out of spec and didn't allow the pieces to come together as designed.
If I were to suggest an enhancement, it would be to add a cross support between the parallel beams, essentially tying the middles together to prevent outward bowing/flexing. There's enough room to do this, so I'm going to drill a few holes and run a thin piece of flat stock. It should increase the rigidity and ensure that the entire perch of the beams/supports are in contact with the board. I might try to weld the vertical supports together as well, seeing as how one simply rests on top of the other and is secured only by one of the two rivets of the cross beams/supports.
Maybe I'm just picky... maybe it's Maybelline.
June 21, 2016
Rated 5.0 out of 5.0 by Art Perfect Shelving unit
Great for want I needed, used as two (2) different and shorter shelving units side by side.
May 17, 2016
Rated 4.0 out of 5.0 by Michael Shelving unit
Good value for money. Needs two people to put together. After first one easy.
May 31, 2016
Rated 5.0 out of 5.0 by R2D2 Easy Assembly
Sturdy shelf, easy to assemble, perfect for my heavy storage items
May 11, 2016