Rated 3.3 out of 5 by 42
Rated 1.0 out of 5.0 by mrdisappointed dont waste your time
Approx half of the parts fit together, the other half wasnt even close. Colossal waste of my time
May 21, 2016
Rated 1.0 out of 5.0 by Review Terrible quality
I purchased both the 36 inch model and the 60 inch model. The difference is night and day. The 36 inch stands securely assembled at it's full 72 inch height in my garage. It even included couplers that allow the stacking of both pieces. This 60 inch model is more like a house of cards. I cannot believe that they do not include any way to safely stack the unit even though it's clearly advertised as 72 inches high. I tried calling Edsal direct several times and they will not return my call even though the piece of paper that comes in the box says "We are here to help". I will be returning this unit to Home Depot.
July 9, 2011
Rated 4.0 out of 5.0 by Strdst Good, but a couple of issues
I got these shelves for storage in my basement. They come pretty much as advertised -- correct dimensions, assembles fairly fast, hold a lot of weight. There were a couple of things I did not like: 1) the upright frame pieces come in two 3ft pieces instead of 6ft each. This means that the middle shelf has to be in the middle to connect the two pieces. You can't adjust it up or down. Also the joint where the two upright pieces attach is weaker than if it was a single piece. 2) The shelves themselves are cheap 1/2 inch particle board. I was expecting metal. They do seem to be holding up fine so far.
May 28, 2011
Rated 4.0 out of 5.0 by TimsShelves solid industrial shelving
Easy to assemble even though the instructions were not great. Feels solid. A little expensive for what it is.
November 12, 2014
Rated 5.0 out of 5.0 by Bob12005 Great shelving!
Shelving is of good quality and easy to assemble. Would buy tem again.
December 9, 2015
Rated 4.0 out of 5.0 by TampaDan Very strong, fixed-position middle shelf, arrived dirty
Heavy duty 60" x 24" are hard to find. I refinished these with stain & polyurethane for an interior closet. They are very strong, but a mallet is needed for assembly. The 72" vertical supports are two-pieces, each 36" high, so you MUST put one shelf in the middle (at 36") to rest the upper supports on that shelf. That limits versatility for shelf placement. The pressed-wood shelves were not boxed when shipped, just banded together so they arrived chipped & dirty. No complaints about the sturdiness & strength, should last forever.
October 15, 2011
Rated 3.0 out of 5.0 by Josh The supports are tricky
I didn't realize until I tried to assemble them that the vertical supports come in two pieces. Since I didn't have help to assemble them, this was a logistical challenge. What saved the day was using quick release clamps to brace the two vertical supports together using a third support aligned with them temporarily. Then I was able to lean the partially assembled frame up against a wall and install the horizontal supports that braced the vertical supports. The I removed the clamps and continued with the assembly. VERY poor design, splitting the vertical supports in two pieces like that. Once they are assembled, the shelves are fine, but they make it WAY more challenging to assemble than they need to.
September 1, 2015
Rated 2.0 out of 5.0 by AMICHIGANBUYER FAILED HOME DEPOST OF MICHIGAN SALES OPERATIONS RELEASEING INCOMPLETE SHELF
THE PINS THAT HOLD THE SHELFS DO NOT SIT ALL THE WAY DOWN WITH THE WEIGHT ON THE SHELF WITH THE HD EMPLOYEES ASSEMBLY .
THE COMPANY EDSAL FAILED TO PROPERLY PAINT THE SHELF WITH THE PRIMER PAINT SHOWING THROUGH .
THE EDSAL COMPANY NEGLIGENT IN TESTING AND BUILDING TO PLACE THE PINS IN THE RIGHT LOCATIONS TO HOLD THE SHELF TOGETHER.
THIS IS A TWO PIECE SHELF POLE SUPPORTS.
THIS MODEL DOES NOT COME WITH ONE POLE DESIGN TO HOLD SHELFS .
HOME DEPOST DID A POOR SALES JOB WORKING WITH EDSAL
June 24, 2015