Rated 3.7 out of 5 by 6
Rated 1.0 out of 5.0 by DIYLady Hollow and flimsy
This gate pull was installed on my wooden gate. The first few months it was fine, it did the job. Several months later (less than 1 year) The handle started tearing/breaking. Later It just ripped off like thick foil paper.
The back side is hollowed out.
I didn't bother checking with customer service or any warranty since it was cheap in the first place.
May 22, 2016
Rated 5.0 out of 5.0 by dsilverback Great
Perfect for what I had in mind. Sturdy, and with room to get my fingers between handle and door for a firm hold.
May 3, 2016
Rated 5.0 out of 5.0 by Backhoe1 Just what we wanted
The door pulls look great on our cabinets. Believe they will be excellent for the wear and tear from shop work
March 11, 2015
Rated 5.0 out of 5.0 by Bill Quality purchase
The handles are a nice size and comfortable grip. The screws that came with it are probably about 1/2" too short. I needed to go through a vinyl board first that left me with minimal bite into the frame.
October 8, 2014
Rated 1.0 out of 5.0 by DanD Not manufactured evenly
Admittedly, I have a good eye for parallel lines, but when I went to install this handle, I found that the door handle was not straight but very slightly curved. That is, the top edge was not parallel to the bottom edge. I only half noticed, when pre-drilling the holes for the screws, that they weren't quite in line... it was only after the handle was up on the door that I stepped back and could see the curve to it. Pretty subtle, but once I had noticed it, there it was. Had to take it down, buy a better handle (metal, painted it black with enamel paint, since I couldn't find a pre-painted one at Home Depot except for this.)
So if you buy this, look very very carefully before you buy. And if you're installing for a customer, make sure the customer isn't one of those people who spots size differences or funny angles, 'cuz this handle's got a funny angle to it.
December 15, 2011
Rated 5.0 out of 5.0 by rjbannon Perfect value
Just what I needed for my job. Its was a good value..
January 10, 2012