Rated 3.4 out of 5 by 41
Rated 4.0 out of 5.0 by ProfessorShadow Great Idea, but...
I believe the intent of the product is an easy cover to make your outlet cover blend in. Which they would earn a 5~Star.
The part where you bend the "Stiff" material over to cover the sides is a 50-50 proposition. Because the material is a bit thick I needed to add a touch of glue to hold the edges down.
September 30, 2014
Rated 5.0 out of 5.0 by Mjh Super Easy to use
We used Fasade Vinyl in our kitchen the pattern matches our tile perfectly
October 25, 2016
Rated 3.0 out of 5.0 by Mike Good product
The adhesive backing is not sticky enough, but can be compensated for by overlapping at least a half an inch over the back. Then taping overage down.
October 6, 2015
Rated 5.0 out of 5.0 by bobo good buy
Easy to fix mistakes with this product inexpensive product that works well
August 8, 2015
Rated 1.0 out of 5.0 by HearMeRohrer Outlet/Switch Plate Cover Sticker Does NOT Adhere! JUNK
I am an avid Upcycling Crafter; I make awesome stuff out of other people's junk. So when I say this stuff is an epic failure, know... This stuff is 100% WORTHLESS. It didn't adhere to any of the backs of our typical, plastic, Cover Plates no matter how long (>1/2") or short (1/4") we 'over cut' it. Funny that I had cleaned each cover plate w/Dawn dishwashing soap and then with white vinegar to ensure all were free of any oils, dirt, etc. before attempting to cover...as my husband insisted it was totally unnecessary and I was wasting time. I set them to 'dry out' for 15 mins, and NOT a single sticker stuck to the back of the cover plate once folded over. Broke out the ModPodge, Locktite Super Glue, Gorilla and a few credit cards. And with both of us pressing firmly down on the credit cards over large area of sticker for a good 1.5mins once glue was applied, still EVERY single sticker cover popped off backside of every cover plate after less than 1 min., no matter which additional adhesive we used.
Wasted 4 sheets of this @ $$38 and ended up throwing it all in the trash. I am writing the company directly next. RIDICULOUS, PATHETIC, JUNK!
September 15, 2016
Rated 3.0 out of 5.0 by Deborah Beautiful Outlet Cover
The peel and stick outlet cover matches beautifully with the backsplash, and I consider it a decent price. I actually ordered more than I needed; one piece could be used for two outlets. The only problem is that it does not stick very well, so I will hold on to the extra ones in case I have to reapply. The look is beautifully, and easy to apply, but every so often, I have to press on a corner or side to stick the cover back down.
February 10, 2015
Rated 5.0 out of 5.0 by Plantlady7 Great outlet cover match for the facade!
Looked at several home stores and nothing mated or complimented the Bermuda façade. This was easy to apply and looks great!
April 22, 2015
Rated 3.0 out of 5.0 by LebanonPACustomer Looks Pretty Good, Difficult to Work With
The final product looks pretty good, but you must take your time and follow the directions and use a sharp exacto knife or razor. Leave a little more on the sides than the directions say to make sure the wrap folds around the back nicely. My biggest complaint is that the product doesn't adhere well to the back side of the outlet cover. Even after folding tightly and pressing for several minutes the product doesn't want to stick to the back properly. I think Fasade should offer covers that match panels instead of this product. All in all it matches the decorative panels and looks pretty good. We'll see how long it holds up.
July 29, 2013