Rated 3.5 out of 5 by 31
Rated 5.0 out of 5.0 by patr backsplash
really easy to apply, cut with scissors and glued with liquid nails, looks classy and everyone thinks it looks great.
May 19, 2015
Rated 5.0 out of 5.0 by bmayb Good product with lots of color selection
- Great product, to match metalic tile or granite countertop colors.
- Covered non-conventional sized switchplate covers.
- on-line price about $1 cheaper than store cost.
- include a squeegy & utility knife in packaging - makes installation easier.
- Screw heads not the same color - either make matching switchplate screw heads or offer small cans of spray paint; sell in the same area as the applique.
-install immediately, as tackiness weakens & raw edges are lifting up while waiting for the contractor to return & finish the kitchen job (dry heat in house?).
-I wanted corners to be smoother, so tried clear nail polish in those areas - clear spray paint sealer would have done better. I think the polish's amyl acetate weakened the tackiness of the applique - once on the wall, with edges tucked under, I'm sure they will be fine.
-create a same-color duct tape - very narrow, to use to hold down edges on the back side of the switch plate.
After covering the 3rd of 13 plates, I became a pro!!!
February 17, 2012
Rated 3.0 out of 5.0 by LebanonPACustomer Looks Pretty Good, Difficult to Work With
The final product looks pretty good, but you must take your time and follow the directions and use a sharp exacto knife or razor. Leave a little more on the sides than the directions say to make sure the wrap folds around the back nicely. My biggest complaint is that the product doesn't adhere well to the back side of the outlet cover. Even after folding tightly and pressing for several minutes the product doesn't want to stick to the back properly. I think Fasade should offer covers that match panels instead of this product. All in all it matches the decorative panels and looks pretty good. We'll see how long it holds up.
July 29, 2013
Rated 4.0 out of 5.0 by ProfessorShadow Great Idea, but...
I believe the intent of the product is an easy cover to make your outlet cover blend in. Which they would earn a 5~Star.
The part where you bend the "Stiff" material over to cover the sides is a 50-50 proposition. Because the material is a bit thick I needed to add a touch of glue to hold the edges down.
September 30, 2014
Rated 5.0 out of 5.0 by DKK13 Easy to work with and it cuts with a scissor!
This was the perfect finish to our project. I was afraid it would look like cheap contact paper, but that was far from true.
July 19, 2013
Rated 1.0 out of 5.0 by JoJo Didn't care for it.
I tried attempted to attach this product to the outlet covers. It stuck to the front, but I couldn't get it to adhere to the back of the outlets, even with E6000 glue. I ended up saving my time and frustration and bought some really pretty metal outlets with a touch of the copper in them. It saved me a ton of time and I don't have to worry about accidently scratching the surface of the covers. I haven't regretted buying the metal outlet covers at all.
January 1, 2015
Rated 5.0 out of 5.0 by bobo good buy
Easy to fix mistakes with this product inexpensive product that works well
August 8, 2015
Rated 3.0 out of 5.0 by Deborah Beautiful Outlet Cover
The peel and stick outlet cover matches beautifully with the backsplash, and I consider it a decent price. I actually ordered more than I needed; one piece could be used for two outlets. The only problem is that it does not stick very well, so I will hold on to the extra ones in case I have to reapply. The look is beautifully, and easy to apply, but every so often, I have to press on a corner or side to stick the cover back down.
February 10, 2015