Rated 2.3 out of 5 by 20
Rated 1.0 out of 5.0 by Tom The threshold is solid and well built. However, installing the vinyl seal is all but imposible. Very poor design. I would not recommend this product t
Installing the vinyl seal was all but impossible. I would never recommend this product!
June 28, 2016
Rated 5.0 out of 5.0 by Jeff Threshold
Bought one today, got it home, adjusted height and width, anchored to concrete inserted rubber. Took about 20 minutes. Highly recommended
June 7, 2016
Rated 1.0 out of 5.0 by FrustratedNeedBeer Great buy if you're looking to Waste Hours Of Your Life installing this!
Let's start off with the instructions. They are confusing at best, and useless at their worst. You are instructed to install the vinyl, take it out, then install the threshold and put the vinyl back on. On what planet is this straightforward and convenient??
Then comes the screws. They are cheap! And ALL of them broke off at the head when the threshold needed to be adjusted slightly. So now, a project! A project to remove the stuck-in-the-floor threshold with a crowbar. I can tell you that is not in the instructions. Perhaps they designed the hardware this way so you can never uninstall it?
The vinyl installation really seals the deal, so to speak. You sit there and gently tuck it in about an 1/8" at a time, on one side only, down the length of the threshold. 36" or so. 1/8" at a time. Then you are free to repeat the fun on the other side! It's a great way to spend some up close and personal time with a household item you will probably never look at again, except in disgust for how much of your life was wasted installing it. If you even get as far as finishing your installation.
DON'T BUY THIS!
June 2, 2016
Rated 1.0 out of 5.0 by Jimbo57 flawed design
This threshold is the worst design, it takes alot of patience to get the vinyl installed. If I had not trimmed the aluminum base I would have returned it. Don't waste your time or money on this.
April 25, 2016
Rated 3.0 out of 5.0 by Lombo Hard but does job.
Like I toohad in strip but after anhour or so I got it in. This needed and does job
May 3, 2016
Rated 1.0 out of 5.0 by noname Incorrect product information
I went to buy this product at the HD in Prattville, AL. However, the info on this website and the info on the shelf sticker do not match the product package. The model # and the bar code i# are identical, but the product packaging says it's adjustable from 1-1/8 to 1-9/16. See pics.
How can I give a rating if it's not even the correct product?
December 15, 2014
Rated 1.0 out of 5.0 by DIYforever Impossible to install the VINYL INSERT
The vinyl insert installation is the major issue with this product. The aluminum is solid and the adjust-ability for height is a good idea. That is until you try and finish the job by installing the vinyl insert. As others have mentioned, it's possible to slide the insert in from the end of the threshold (to test the fit), but you can't do that after you install the threshold. Mind you, it's the only way to get the vinyl insert to go into the track. The vinyl insert "hints: to make the vinyl insert easier to install", are obvious clues that this design is a problem for many. I am sure it sells a lot of replacement inserts because you ruin a lot of them trying to jam it into the slot!
December 18, 2015
Rated 1.0 out of 5.0 by Dan Do not buy
This threshold should be taken off the shelves..period..anyone who tries to get that vinyl strip into the grooves is in for a real tough time,the gasket is too iarge for the groove it is suppose to go into.I wasted 2 hours trying everything to make this work, soapy water..wd -40..it is a obvious design flaw and had to go return these 3 thresholds and buy others that actually worked first time . Now I wasted over 4 hours of my workday on a product that shouldnt even be on the shelves..it is that bad..never again will I buy ANY frost king product, I just do not have that much time to waste on inferior products.
June 8, 2015