Rated 3.7 out of 5 by 13
Rated 3.0 out of 5.0 by jillwigs looks good but a cheap product
Did not fit around ceiling fan base. Had to sand down to get to fit. Not very sturdy so sanding was tricky to not break item. Did not fit well together and did require careful attention to get them to line up and fit together. Easy to paint and they do look good. For price was just expecting them to be better made. Hope they hold up! With all said they do serve our need, but would buy solid piece next time and just take down fans to install.
October 15, 2013
Rated 4.0 out of 5.0 by Judy Split Medallion
It's pretty-Just wish it had fit around my light fixture- was too big. Wish you had other sizes. Split medallions are hard to find.
December 15, 2015
Rated 1.0 out of 5.0 by Rick Disapointed
Poor fit. Item required a lot of modifying. No quality control at factory.
September 22, 2015
Rated 3.0 out of 5.0 by SEF Not as good as the first one I ordered
This medallion needs filled in the seams. It wasn't cut as well as the first one I ordered in the same pattern. So the quality isn't consistent. HD needs a "maybe" in the recommendation box
August 25, 2015
Rated 4.0 out of 5.0 by housewrecker A pretty good product for our purposes.
We needed two-piece ceiling medallions to cover drywall damage in the installation of two LED can-type lights in the master bath. One piece meds would have required the removal of the entire lights. The two-piece are held in place by the tension of the light fixtures so we don't have to affix them to the ceiling with glue or screws, which would greatly complicate changing of the bulbs when . needed. They look good and cover the hole in the ceiling. I was hoping that they would snap together but they don't so we have two pieces held up by the tension in the can lights. All in all an adequate solution for our problem.
January 11, 2014
Rated 5.0 out of 5.0 by Marylanddiy Great look
It was easy to install. Looks really nice too. Highly recommend it if you need to cover the opening around a ceiling fan.
July 8, 2015
Rated 4.0 out of 5.0 by nerdoloco Did the job fine
I needed a two piece medallion to go around the cap of my ceiling fan without having to take the fan down. There was also a two inch gap in the ceiling at different points that I reinforced with thin planks. So the medallion had to also accommodate the planks and stay flush to the ceiling. I did have to cut the hole larger to fit around the cap, which took some time. I just used a serrated knife, nothing fancy. I smoothed it out with a blade. The foam was easier to cut than I thought it would be. I managed to attach it by myself. After getting it the right size I put caulk on the medallion and laid it flat against the ceiling and wedged two rolls of masking tape between the medallion and the fan blade for support while I hammered two finishing nails into opposite sides of the medallion half. I left the tape rolls overnight to give it plenty of time to dry and the next day I finished the other half leaving the tape rolls as support overnight again. Then added a third finishing nail to each half, caulked the gaps and nail holes, and painted. It worked fine over the planking and textured ceiling without leaving a noticeable gap. I'd give stars if not for the fact that it took several days and some cutting to get the job done.
February 17, 2015
Rated 3.0 out of 5.0 by KAmonroe Does the job but....
This medallion is very attractive however the seams do not mesh together perfectly so you can see the seam joint at both connections.
December 10, 2014