Rated 4.4 out of 5 by 65
Rated 4.0 out of 5.0 by None Household Replacement Filters
The filters are recommended for our well water and do a good job of filtering.
May 24, 2016
Rated 4.0 out of 5.0 by BusyPap original replacement
Filter is original replacement rated at 15 to 30 mirc. Store has quit carrying these and now stocks 5 micr which only last half the gallons and clog much more quickly.
January 12, 2016
Rated 5.0 out of 5.0 by yogi Process worked well
Routine replacement filter. I do it every year. This year the local store wasn't carrying the product and the staff member recommended I order it through the catalog. Process worked as advertised.
December 31, 2015
Rated 4.0 out of 5.0 by none water filter
filters are no longer stocked in store so I had to order them on-line and pick them up at the store.
November 3, 2015
Rated 1.0 out of 5.0 by Patches Replacement water filter
The filters are of different dimensions than the original filters distributed by the manufacturer. They do not work in our original filter holder because they are too small in circumference.
October 7, 2015
Rated 5.0 out of 5.0 by me Replacement filter cartridge
I installed the water filter system for my washing machine and it has worked great.
September 2, 2015
Rated 2.0 out of 5.0 by adf Get what you pay for
Very inexpensive. but only last a week or two. You get what you pay for
August 4, 2015
Rated 3.0 out of 5.0 by Bob Basic filtering, little flow loss
Before I installed this I used the GPM flow rate on my water softener before and after to see what I was losing on GPM. Bottom line it is pretty minimal with the new filter, but I don't know yet on an old one.
My water softener has 1-1/4" input/output, which is the same for my house water supply, so I had to reduce down to 3/4" for this filter housing. I turned on 3 showers, 4 sinks and two garden spigots full blast with both cold and hot before installing, and measured about 17 GPM before installing the filter. The same test after the filter install was about 15 GPM
As perspective, a typical shower head is designed for 2.5 GPM or less. If you remove the shower head restrictors, you may get around 4 GPM
So even though I had to reduce my supply lines from 1-1/4 to 3/4 at the filter, I really didn't lose enough flow to make any real difference. I can still run all three showers and a few other things at the same time
The smaller micron filter has a specified flow rate of 5 GPM, which would be a huge loss for my case, but still might be fine if you're only using 1 shower and nothing else at the time
July 7, 2015