Rated 3.1 out of 5 by 13
Rated 5.0 out of 5.0 by Sebastian The greatest of all in this category.
I would say that GE's Silicone II 10.1 oz. Kitchen and Bath Caulk is the greatest of all in this category.
This time I picked the white, since I was re-caulking my white shower. Even though it says
.7 year mold-free product protection for me it had gone to 12 years.
This GE's 100% Silicone is 100% Waterproof and it a great product., and I love it because it also has Mold free product protection.
October 3, 2016
Rated 5.0 out of 5.0 by LocalCustomer Works well, recommend.
This product is highly rated by many, so I gave it a try in my bathrooms. Applies well and dries quickly. No issues so far; time will tell how well it holds up.
September 6, 2016
Rated 1.0 out of 5.0 by NiJo DO NOT USE!!!!
If I could give ZERO stars I would. Stay away from this. I've caulked a lot of stuff in my life and on a new tub I thought I'd give this a try. It was a disaster. The chemical cured way too fast. Like in the 4 minutes it took me to apply the tube, the starting point had become too tacky to even smooth over. Maybe GE is over-compensating for the non-drying issue other posters commented on. Either way, this job that should have been easy will now take me extra hours of cleaning and scraping to get back to a point of doing it over. What a waste.
June 13, 2016
Rated 5.0 out of 5.0 by Jimmy great stuff
I've never used a better type of caulking. always check the expiration date before buying the tubes and it might solve the problem of not curing.
June 4, 2016
Rated 1.0 out of 5.0 by Home Defective
Product never dried. I let sit for 2 days, and it never dried.
May 11, 2016
Rated 5.0 out of 5.0 by DIYNUT Good sealant
I have used it many times, works well. It seems To be durable.
April 28, 2015
Rated 5.0 out of 5.0 by Jon Great stuff- pro tip below
This is the best silicone you can use in your bath/shower area. It will never mold if you install correctly and don't have wide thick bands of extra silicone protruding out from the corners. This is where mold growth starts. Follow the tip below for a flawless job:
Pro tip - cut off the tip of the tube with a sharp razor at an angle - never use the built in cutter on the caulk gun. Make sure the hole isn't too big when cutting. Apply your bead with slow steady pressure - don't overload your corners. Before smoothing, spray an ammonia free window cleaner over the top of your fresh bead and surrounding area. Also put some window cleaner on your finger. Run your finger down the joint with light pressure and clean your finger with a rag to remove excess silicone frequently. You'll be amazed at how well this trick works. The window cleaner does not harm the product. Once your done, let the excess cleaner dry on its own. Don't try to wipe off - you'll ruin your work. I've been using this trick forever - learned from a pro storefront window installer years back.
March 14, 2016
Rated 1.0 out of 5.0 by Charlie It dos not control the mold at all!
I had used this product to caulk around the bathtub by following the instruction in the bathrooms twice. 6 months after the mold grows up right on the product. Disappointed.
February 5, 2016