Rated 3.6 out of 5 by 17
Rated 4.0 out of 5.0 by Shane Does the job at great value
Do yourself a favor and do what other commenters have done is buy yourself a 1-1/2 inch diameter, 2 foot long piece of PVC pipe so you can ensure you are at the height you need it when complete. (if you end up not using the pipe, you are out 4 bucks). Dig a hole, bury the pipe in the hole with quick-setting concrete, then insert the post over the pipe. Simple enough to do. If you want to stiffen up the post, pour some concrete down inside the post to stiffen it up. If you feel the bracket is a little flimsy, use some thread locker while installing the bracket to ensure the nuts don't come loose pre-maturely.
It's a great value, not the prettiest set-up, but it gets the job done.
February 29, 2016
Rated 2.0 out of 5.0 by BirdBrain Too short, bit on the flimsy side. Gets the job done, but barely.
It was easy to assemble, but after the very first day on the street, I got a note from the postal worker that it was about 12 inches too low. To raise it to their recommendation would leave me only a few inches left to actually put in the ground. Thanks to another reviewer, I jammed a length of 1 1/2" PVC pipe in the end to extend it and get it up to the height I needed. They should sell an extension piece for this unit.
Other than the height, the quality of the box feels a bit flimsy, but for the price, I'm hoping I get at least a year or so out of it.
November 11, 2015
Rated 5.0 out of 5.0 by Danno All you need in a mailbox
There is no need to spend more than this on a mailbox. Assembly is easy, dig a 20" hole, insert the post, add some concrete. Done.
November 10, 2015
Rated 4.0 out of 5.0 by MJaz good value
As far as mailboxes go this one is fairly typical. For the cost, it's hard to beat. I was a bit skeptical about the length of the post and when I assembled it and checked the height of where the box needed to be, I discovered I'd only be burying about ten inches of the post which is not enough for stability.
To remedy that problem I used a 6 ft. Heavy Duty Steel Green Painted T-Post (less than $5) and drove that into the middle of the 10 inch deep hole and then placed the mailbox post over that. I filled the hole with cement and job done in about 30 minutes.
March 23, 2015
Rated 2.0 out of 5.0 by 9232Pippin Tinny build quality, post too short
Mailbox and post are light gauge metal. Wasn't too hard to put together. I don't expect this to stay rust free for very many years. It also would have been nice if the post were long enough to mount to USPS regs (41"-45"). Considering that the instructions emphasize the necessity of contacting the post office for the correct height/setback dimensions it's puzzling that they short-change us on the post height. Would not recommend.
April 19, 2015
Rated 1.0 out of 5.0 by Jenn Not worth buying
Purchased this mailbox a few months ago and it has already fallen apart. The directions were easy to follow and assembly was easy, however after assembly I noticed that the mailbox itself would wiggle because the holster only sits tight around the post, not actually through the post, so it allows for the box to wiggle. I am constantly tightening the screws to secure the box. Anyways after its first snow storm, the mailbox top wiggled off. I would not recommend this product. Cheap quality. Spend the extra money and get a decent setup.
November 26, 2014
Rated 3.0 out of 5.0 by Sequoiahealth Nice Mailbox But Post Too Short
Assembled mailbox per instructions including digging a 16 to 20 inch deep hole. Come to find out that after allowing for the USPS 44 inches ground to bottom of mailbox requirement I had 6 inches of pole left...Hmmmmm So back to Home Depot to find a 2 foot piece of 1 1/2 PVC to stick in the bottom of the mailbox post to give me my required depth.
May 8, 2013
Rated 2.0 out of 5.0 by JImC Not very sturdy
I found this mailbox nothing but annoying. Despite setting the post in concrete it still manages to spin. Why make a round post? The mail box attachment to pole is not very sturdy and wiggles event though I tightened the out of them.
October 12, 2013