Rated 2.5 out of 5 by 20
Rated 3.0 out of 5.0 by Willie You pay for what you get
Cheaply made, The doors barely line up, gaps are inconsistent. If I were buy this for a high end house, I would be disappointed but I bought it for my tiny cape and it does the job for now. When the door is closed, it's difficult to open because there is no bottom lip to grip.
October 11, 2016
Rated 2.0 out of 5.0 by Rb Not the best quality
For $100 I thought it would be made better. It came with a lot of marks. Made of particle board and not all real wood.
August 30, 2016
Rated 1.0 out of 5.0 by JLA Poorly made
very poorly made. not worth putting up. boxed it back up to take back to store.
August 3, 2016
Rated 4.0 out of 5.0 by 93428x2 Nice cabinet.
A bit on the small size but nice for a rental. Fits equal to the cabinet below.
July 19, 2016
Rated 2.0 out of 5.0 by Delia1776 Looks good out of the box, but doesn't hold up well
This looked really nice, and went up fairly easily, but it simply hasnt held up at all. One door-hinge started to loosen up and then the whole particle door ripped off, and its pretty much unfixable. Another door started to do the same so i tightened it immediately but it looks pretty crummy, with one door missing. Plus, the shelves are not laminated at all - so its just yucky where we keep the toothbrushes. If you are a builder i would spend just a little more, because this cabinet will likely be a problem and cause your buyer to question your quality.
October 12, 2015
Rated 3.0 out of 5.0 by Shacker Don't expect too much for $100!
If your faucet cost more than $50 you will want to get a better cabinet. The quality is as described in other reviews - about as low as can be expected to hold together. I mounted it with three screws across the top into studs but had to add several more because the back was so warped the shelves could not be installed.
September 8, 2015
Rated 1.0 out of 5.0 by Bilbo Oh No
I was really concerned upon unboxing the cabinet after observing the basically cardboard rear panel. I purchased the recommended mounting screws and flat washers. Drilled pilot holes in the flimsy stiffener located inside the cabinet and located near the top. Installed a screw in the upper right corner. Placed a level on the bottom "frame" and after leveling installed a screw in the upper left corner. then proceeded to install two more equally spaced screws in the top "stiffener". The wife walks in and says it's low on the left side to which I replied...impossible as I used a level. Upon moving the level to the right side it showed she was right. After checking the construction I found the left side panel was misaligned with the top frame. After observing a droop in the top trim The small strip of compressed wood in no way was stiff enough to keep the top straight. Flimsy.....returning the unit in the morning!
August 14, 2015
Rated 1.0 out of 5.0 by Andrade poor quaitly
When we removed the cabinet from the box, there were several cracks in the door frame and top piece. It was obvious it was done at assembly from the door hinge and stapled corner joints. The materials seem flimsy and weak. I was afraid to hang it or put anything in it. The shelves bowed and flexed when trying to install the shelf hanging plugs. The interior mounting panel popped off while trying to drill holes, it was simply glued on with several short staples. As soon as the drill hit it it was off. It had many nicks and dents in the outer coating. Overall, very disappointed. I expected better quality for the price. We did end up hanging it out of desperation. I hope it lasts long then a few uses of opening and closing, which is what it feels like when you open and close it.
February 23, 2015