Rated 4.8 out of 5 by 29
Rated 5.0 out of 5.0 by DocGraves Organizing
Have purchased this product before and continuing to organizing the garage to make it more user friendly.
September 30, 2015
Rated 5.0 out of 5.0 by nelson Good quality
A must for any garage. Easy to install. Looks clean
September 15, 2015
Rated 4.0 out of 5.0 by Cow Great product boxes were in bad condition
The boxes were in very poor condition, one of the panels were broke inside. I did not return, i worked around the break
September 1, 2015
Rated 4.0 out of 5.0 by Butch Good find
Good find for our garage. The strips could have been not as wide, but still was good to accomplish what I needed. The ability to place the hooks at any location is the key to making this a successful purchase.
August 25, 2015
Rated 5.0 out of 5.0 by papa Great product
Panels were easy to install, even easier with predrilled pilot hotes. Panels look great installed beneath my gladiator cabinets. By the way, most Craftsman Versa Track componenets will also work with these panels.
April 25, 2015
Rated 5.0 out of 5.0 by mronedrfull Absolutely great garage organization and storage product!!!
I did a lot of research on various garage organization and storage products and the reviews were almost unanimous...Gladiator is the way to go! I use various Gladiator hooks and shelves to get everything (i.e. tents, coolers, brooms, hoses, ladders, shoes, etc.) on my garage walls so nothing is on my garage floor. I've even received numerous compliments from my friends!
June 24, 2014
Rated 5.0 out of 5.0 by JimL beat slat wall system
There are a variety of wall hanging systems. WARNING: You cannot assume BTW that accessories are interchangeable among wall systems. The slat wall you see on store walls is heavy and has narrow channels, Unless you live in a big city, it is hard to buy 1 or 2 4x8 panels.
These 1 foot wide 8 feet long tongue & groove panels are light, easy to use, and easy to install. The accessories attach easily.
Plan on 28 screws per 1x8 panel. The factory recommendation is #8 1.25"-2" flat head deck screws. I used #12 2.5" stainless screws since I was mounting on treated wood studs. The tongue & groove seemed to fit better when I slid the top panel back & forth sideways a bit (vice tapping with a rubber mallet).
An easy way to start the first panel is to mount a straight, level board, then simply set the first panel on it.
Since these are marketed to DIY, I'd recommend the instructions address common wall problems (e.g. wall not straight, studs not even, etc.). For example, position your first panel on the floor where you want it to go, then check stud locations. You may want to put in sister studs in corners or at panel ends.
July 18, 2014
Rated 5.0 out of 5.0 by Steve Excelllent product.. easy to install
Overall, great product and looks nice. The only thing is the cost is kinda of high. If someone used these in their entire garage it would add up quickly.
April 7, 2015