Rated 4.0 out of 5 by 43
Rated 1.0 out of 5.0 by Sawhorser Does not fit HD's own 2x4 lumber.
These brackets are cheaply made, and they don't fit Home Depot's own doug fir 2x4 lumber. Spend a few extra bucks, or build your own.
October 19, 2016
Rated 5.0 out of 5.0 by Dan easy to use
I bought 2 sets of these only took minutes to put together so they are very strong but definitely recommend
October 4, 2016
Rated 5.0 out of 5.0 by JG Saw horse bracket
Decent quilality. I had to bend the channels open a little to get the 2 x 4 to slide in. But, otherwise a good product.
September 10, 2016
Rated 4.0 out of 5.0 by eee 5.48 IN. 10-COMPARTMENT SAWHORSE BRACKET
Price was responsible and the brackets seemed to be sturdy when properly assembled. I'v used them for several projects and will most likely do so again.
August 30, 2016
Rated 5.0 out of 5.0 by ALH Good simple product
Brackets are well made for the price and easy to use!! Would have made the job of making a set of saw horses very easy if the 2 x 4's were cut correctly! A 2x4 is now really 1 1/2" x 3 1/2". The ones I picked up had several that were 1 3/4" x 3 3/4". I didn't check this before I started cutting my pieces. All of my legs (which slide into these brackets) were 1 3/4" x 3 3/4"!!!
So I had to go buy more 2x4's for the legs.
Make sure you measure your 2x4's when you purchase!
July 26, 2016
Rated 1.0 out of 5.0 by newt junk
this item is flimsy shaky far from sturdy as one can get. I built the item and had to screw extra boards to to structure because it was so wobly. the brackets are not very strong at all. with all Mt labor and suplies I may as well have bought a different product
August 6, 2016
Rated 4.0 out of 5.0 by RadiologyKen Decent for price
Bought these for a quick fix for a bending brake needed at my house. I used the "purple" lumber at Home Depot and got pressure treated 2x4's for next to nothing. Total investment was $15 for 2 saw horses! Can't get plastic ones for this price and 100x more sturdy! I used 1.5 inch deck screws to secure the legs into the bracket. Same screws for the cross brace. I think using 2 inch screws would have been better for the cross brace. One of the screws popped out because it did not grab enough wood. When making the legs, I cut the bottom at a 15 degree angle to have it sit better on the ground. Most mitre saws should have a detent for 15 degrees.
The only reason I am knocking a star off is because one of the rivet hinges snapped when putting the legs together. Luckily I had the appropriate rivets in my shed. Used one and it was good as new.
June 21, 2016
Rated 3.0 out of 5.0 by RCM Not quite as expected
I purchased these along with some treated 2x4's.... The wood would not fit into these brackets. With a large hammer and an extra set of hands, I was able to get this to work. More work than I expected.
July 12, 2016