Rated 4.8 out of 5 by 9
Rated 4.0 out of 5.0 by Eddie127 Drywall Patch
A nice easy patch for drywall holes. Just slap it on, spackle and sand when it dries. It will not be perfectly flush with the wall, so if that isn't a concern I would recommend it.
June 30, 2016
Rated 5.0 out of 5.0 by RC Drywall repair patch
It was easy to repair the hole in my wall using this repair kit.
July 16, 2016
Rated 5.0 out of 5.0 by Jamest It works
The HDX dry wall patch worked good for me. I had removed a wall mounted sink that was glued direct to the sheet rock. It left a deep hole where a chunk of sheet rock pulled out with the sink. I tried repairing with fillers and they did not adhere well and seemed to never get completely dry or hard. I then went over the top of my failed repair with a 4"'x6" HDX patch, followed the instructions and worked drywall compound over the repair. After sanding off the excess the repair was sound and looked acceptable.
November 7, 2015
Rated 5.0 out of 5.0 by TC Worked well and did the job
Very easy to use and I used it to fill a 8" hole in a sheetrock ceilings.
April 26, 2016
Rated 5.0 out of 5.0 by doglover77 Patching a large hold became easy!
My new lab puppy had decided she loves the taste of drywall ... And leaves rather large holes in the wall. Thankfully this product makes it a breeze to cover up! Now - to find something to stop her eating holes that's this easy ......
February 23, 2016
Rated 4.0 out of 5.0 by AEJ Drywall Repari Patch
The patch worked fairly well, but if you need to cut the patch to fit the hole, you tend to lose some of the edge surface which makes it more difficult to stick the patch to the wall. This requires you to use more "mud" to hold the patch onto the selected area. If the whole patch is used at one time, this problem seems to be eliminated.
February 4, 2016
Rated 5.0 out of 5.0 by ILWR Good Purchase
Patched very well and would use it again. Thank you.
February 23, 2016
Rated 5.0 out of 5.0 by stargazer replacement ballast
The ballast was easy to install. Wires were connected to the existing wires with electric fastners.
November 3, 2015