Rated 4.3 out of 5 by 9
Rated 5.0 out of 5.0 by Wolfy Trusted, Tried and True
The design and construction of the HALO H71CAT met all my needs. I've used it several times in the past and just bought a Six-Pack to do a workshop in my garage. The quick connectors inside the housing made my job very easy.
Good Design, reliable and easy to use. I won't use any other brand.
October 18, 2016
Rated 4.0 out of 5.0 by Tony Very easy to install!
I'm replacing the recessed lighting in my house because the fixtures installed by the previous owner are not insulation rated or air tight.
Because I have an attic, I can use these new construction lights.
These fixtures are great because they come not only with the nails already attached, the electrical jbox already has the push in connectors attached.
Buying six at a time makes this a product very affordable.
September 20, 2016
Rated 5.0 out of 5.0 by Handyandy Excellent Value
Electricians found this product easy to work with. Ceiling placement went smoothly in attaching the housings to the ceiling rafters.
September 20, 2016
Rated 3.0 out of 5.0 by Electrical Nice can, Horrible nails
This is a great can, and I use them often. Unfortunately I usually end up attaching them with screws because the nails bend so easily.
July 26, 2016
Rated 5.0 out of 5.0 by Baldy Halo Can Light
Halo has always made an excellent product. These are no exception.
April 12, 2016
Rated 4.0 out of 5.0 by dogsailor Good light
These lights work well and are easy to install. The plug in connectors make the process quick
March 1, 2016
Rated 4.0 out of 5.0 by cowboy lighting
they are easy to install. they look good and are priced right
September 1, 2015
Rated 4.0 out of 5.0 by BtMinTX Versatile, value
Bought two of these ICAT 6-packs from Home Depot, and they were exactly what I needed. The original builder put in non-IC rated cans with blown-in insulation. Since this is a fire hazard, I replaced as many as possible. If I didn't have insulation or drywall, these would have been easy to install. I really like the push-in wire connectors and lock-in systems.
Note that these are new-work, so the tabs might not fit under finished-ceiling joists. Bend them up to avoid drywall/nail pops. The airtite strips didn't always line the light/ceiling gaps (but are at least present), so I sealed the gaps using UL butyl tape that hides behind the trims. Certain sized lights may stick out below, even with the 30_AT trims, so either use bulbs smaller than PAR38 or a different can with the socket hooked to the top.
August 19, 2013