Rated 3.8 out of 5 by 57
Rated 1.0 out of 5.0 by Shep1 Good idea but poor performance!
Within a few hours of installation it became intermittent. Work sometimes, then not. Good concept but only if it works reliably.
June 9, 2015
Rated 5.0 out of 5.0 by Tuna It works
My old x10 remote stopped working. This was a reasonably priced replacement. Used it for one of the three ceiling light sockets in a high ceiling loft that all operate off a single switch. Needed to separately control one of the sockets while the other two were on and this works just like the old x10.
March 3, 2015
Rated 5.0 out of 5.0 by Silverfox Solves a problem
Sure makes it easy to control lighting in an obscure area.
January 27, 2015
Rated 1.0 out of 5.0 by frank not worth the time to order
Went through a lot of effort to get the correct frequency to eliminate interference with other rf switch. Installed and it worked twice and then would not turn off. Returned product.
October 28, 2014
Rated 5.0 out of 5.0 by DDALEX Heath-Zenith-Lamp-Socket
Product works very well; looking to buy a few more.
November 11, 2014
Rated 5.0 out of 5.0 by dd26 works great!
This product works great. I was able to put light with switch in both sides of my attic without the price and inconvience of hiring an electrician. I previously had pull cords for lights.
The one thing I had difficulty with was that I was sent the same channel for both switches and this would not work from both ends of house. Home Depot was helpful in contacting company and getting me a different channel. There is not an option online to specify different channels when ordering as customer. Switches must be 100' apart in order to work on same frequency.
April 10, 2012
Rated 5.0 out of 5.0 by MrsC Works great!
This was very easy to install and works great. I did not come across any of the issues listed in other product reviews. Only drawback is that the glass globe does not fit around the bulb due to extended length. Good purchase.
January 3, 2015
Rated 5.0 out of 5.0 by DIYDude Did the trick
Replaced a previous hanging light for my elderly parents that had a thumbscrew switch at the fixture. Since a duplicate light was impossible to find, I installed a direct wired light. This unit made it switchable from a convenient location for my parents. The screw-in bulb holder/receiver pushed the light bulb out to be more visible, but a frosted deco bulb did the trick. This unit is designed to work better with upright shaded lamps, but was adapted to work nicely with an open hanging light.
January 21, 2014