Rated 3.9 out of 5 by 14
Rated 1.0 out of 5.0 by MonktonBuilder Do not use on bare wood!!!
NEVER use this product over a bare plywood substrate as a bond enhancer for peel and stick tile. You're better off with the original sanded plywood, as this product will raise the grain and prevent a good bond with the tile adhesive. I learned this too late in the process which caused me a lot of extra work. I had to sand the floor with 180 grit paper, which smoothed the surface and enabled the adhesive to work. Unfortunately, over half of the floor was laid before I realized what was happening. Heating the tiles with a heat gun then rolling them worked on some, but others are still not sticking over the entire surface, so they have humps in them where they did not bond properly. A complete disaster.
February 18, 2016
Rated 5.0 out of 5.0 by Sandyjeans One easy job!
This is as thin as milk, spread beautifully and evenly on our sub-floor before putting down the tile. No odor, super easy application. Plan more on 90 minute dry than 30, which was our case. Highly recommend this product.
We used a long handled low nap roller. Good idea to put it down before you go to bed, you will be all ready to do tile first thing in the morning!
September 3, 2015
Rated 5.0 out of 5.0 by Lakelover Great product. .
Helped my vinyl tile stick to and stay on old vinyl. Be sure to clean old surface before applying. I used a paint roller and it worked great. I hope it last.
June 19, 2015
Rated 2.0 out of 5.0 by doitagain no good
does not work!!! floor is coming up. glue is better. easy to put down will not use again. Have to do the floor over.
April 28, 2015
Rated 5.0 out of 5.0 by Mitch Worked well
The product worked well. Store employee was not very accurate in describing the size that we needed to purchase. We only ended up using around 25% of the bottle and could have saved a decent amount on money getting the smaller option.
April 8, 2015
Rated 5.0 out of 5.0 by Jimbo Excellent product
Make sure the floor is complete dry, I used a paint roller for application floor turned out perfect many compliments. Installed black & white tile in three car garage, fist DIY of tile installation.
April 12, 2015
Rated 1.0 out of 5.0 by Megs Didn't work
I spent hours prepping the floor, scrubbing it clean, sweeping it, etc. The floor was ready for the primer. I put the primer down and it took about two hours to dry. The floor is concrete. I put the vinyl tiles down once the primer had dried. It's been less than 24 hours and they're already popping off. Really, really aggravating. I did an entire room and now I have to go buy glue, peel them up, and put them back on. Terrible product. I'll be returning what's left.
January 24, 2015
Rated 5.0 out of 5.0 by mindless06795 Make sticky, stickier..
I would recommend this to anyone using self stick tiles. Make sure your floor is super clean, put this down and wait for it to dry, the lay your sticky tiles down. This will help set them in and they will never come up. Goes down really easy and dries quickly. A must use enhancer.
March 16, 2015