Rated 2.8 out of 5 by 63
Rated 1.0 out of 5.0 by David Lost for next step
I bought this 4 weeks ago at a local Home Depot. It came highly recomended from the store. I had to redo the bottom of our one piece tub that was installed 2 years ago. There were small nicks and scratches on the bottom. I followed the directions 100%. We have another bathroom so waiting to use this one was not an issue. After 72 hours I touched the edge to make sure it was dry. It was sticky so I waited another 24. Than again tacky. Another 24 getting there. After 7 days the edges felt fine and smooth. My wife and I both used it in the AM on day 8. When I came back home yesterday this is what it is. I was better off just leaving it alone. NOW it looks worse than just a couple hairline scratches. Now I have to remove the whole tub and replace it because I used a product that was not designed for tub floors. Home Depot said there was nothing they could or wanted to do. I would not recommend this product for a floor. And yes there was good heat in the room and no humidity.
July 17, 2015
Rated 1.0 out of 5.0 by FredF Doesn't dry properly...ever
Like many other reviews here, this stuff never dries thoroughly. I followed the instructions perfectly when refinishing a bathtub. Weeks later, any item I placed on the paint (shampoo bottle, my butt, etc) would leave indentations. Homax replies to all of these bad reviews implying that people aren't following the instructions. Sorry Homax, there sheer volume of poor reviews here seems to say there is something very wrong with your product. Maybe something has gone wrong with your manufacturing process recently. Stop blaming the customers for your poorly performing product. If you want to leave any feedback for me, please include detailed instructions on how to strip your semi-dried paint from my tub so I can refinish it with some other product.
March 11, 2015
Rated 5.0 out of 5.0 by Itsdaking Excellent product!
What a great option to replacing with a new tub! My tub is 38 years old and looked it. A new tub wasn't in the budget. For less than $40 dollars and some time you can have a nice looking tub. I read a lot of the reviews and clearly an experienced person will have an easier time applying this. With that said here's what I found to be true. First the tub was not even close to being ready in 3 days. I left it to cure for 2 weeks. Keeping the temperature at the specified 72 degrees seemed to help as I could tell the difference in the drying when it was hotter. Second don't use a cheap brush. The bristles will break off and get stuck in the epoxy. Also, I used both a brush and a roller. On the first coat I was just going to use the brush to get in the corners but it went on so easy that I just went ahead and finished with the brush. The second coat I used the roller and used the brush in the areas that were not flat. The roller worked really well to coat the flat areas. If you have basic knowledge of painting and know how to paint with a "wet edge" then you shouldn't have any problems doing this tub. To the one reviewer that ended up with an "Almond" color I think the issue was not stirring the epoxy long enough for it to become white. Again experience with painting will go a long way with this product. Last thing is this product is not perfect or equal to a new tub but for the price this is a great product and well worth the effort. I'm going to use it on my other tub and my sinks too!
May 19, 2014
Rated 5.0 out of 5.0 by SFgal HIGHLY RECOMMEND for those on a budget! Saved us a bundle.
We recently purchased a house, but it's a bit of a fixer-upper and we can't afford to replace everything, so I started google searching budget remodel ideas and eventually found the though-as-tile product. I figured if I could give our (split) bathrooms a facelift for less than $40/box it was worth a shot. I purchased 4 boxes of the brush-on product ($37ea), picked up a vanity on sale($99+$30 faucet), and a new light fixture ($50) and spent a 3-day weekend on the project. i used the product to paint the tiles on the walls and in the shower. i did not use the product on the tub itself. i used an electric hand sander with 35-40 grit sandpaper (there are warnings not to do this that it will tear up the surface, but I did not have an issue), and i prepped the surface thoroughly once. Honestly if I'd have had the patience I definitely think a second or third prepping session would have been a good idea (instructions say to prep 3x). The actual painting part takes much much MUCH longer than I had anticipated. The paint is thick and sticky, and you really need to apply it in relatively thin coats for an even finish. Also found that the instructions aren't kidding when they say to paint in a single direction with overlapping strokes. If you think this stuff will go on just like painting a wall in your living room, you are wrong. If you are painting a large area it will take a long time and it will be painfully slow at times. I also didn't follow the instructions about using a good quality mask (or any mask at all) and I was quite ill with a horrible headache the next day... but a few advil and it eventually went away. It took 3 cans of the product to paint 2 coats for my project. I kept the 4th can for touch ups, and turned out I needed it though not a lot. When I taped the tiles to paint the walls, some of the tough-as-tile paint pulled off when I removed the tape. There were only 3-4 bits that pulled off, and the amount that pulled off was smaller than a fingernail size. I just touched up the few spots with the extra product, no biggie. I think the bits might not have pulled off had I done the 2nd or 3rd recommended sanding/prepping sessions... Definitely wait the full 72 hours cure time per the instructions too!... All in all we're very pleased with the results. It's been a couple weeks since we painted the bathrooms, and so far so good! We were able to completely re-do the (split) bathrooms for less than $400 and would highly recommend this product to anyone with icky tile to cover on a budget.
November 28, 2013
Rated 1.0 out of 5.0 by Mike Disaster
Save yourself $40 and buy 2 cans of epoxy paint, a bathtub cleaner, rubber gloves and a good scrub brush. That's all this "kit" is, except instead of a good brush they give you steel wool that makes your barely noticeable brown stains horrible gray stains.
September 20, 2015
Rated 1.0 out of 5.0 by JerseyKat1 Didn't Work
We bought two of this product to refinish the bathtub and surround. Followed the directions to a T as my nephew who applied this is a professional painter. Looked nice in the beginning, but then it began to peel off, at first a little, then a lot. Ended up buying a new bathtub and having the surround tiled. This was a huge waste of money, not to mention time, energy, drying time, inconvenience, stink and disappointment. Attached photos show the paint beginning to peel, but it got far worse and the peeling paint would prevent the water draining from the tub as it would collect in the trap. What a mess.
July 2, 2013
Rated 2.0 out of 5.0 by Girard714 Miserable Product
I followed all instructions and ended up with a heavily brush marked surface. While it was drying some spots bubbled. It did not hide the old sink very well. After 1 use the plastic tub i had in the sink left a ring . The same happened where the dish rack sits. Very dissatisfied with this product.
July 13, 2015
Rated 2.0 out of 5.0 by gwidme01 tough to use
I bought this product to refinish an aging stained bath tub. I cleaned the tub as described in the instructions. The brush-on epoxy is sticky and difficult to apply evenly. After applying the second coat, coverage was ok but the finish was far from even. Hard to avoid tears forming on vertical surfaces, even when applying thinnly as recommended. Epoxy takes a long time to dry. I did project in winter and had to used a space heater to keep the temperature of the bathroom around 70F. After 4 days of cure time the epoxy has not completely hardened. In some spots the paint has wrinkled and I am not sure it will adhere permanently. Looks like this job will have to be re-done (with another product). Make sure to have a proper respirator handy as epoxy generates A LOT of fumes. Doing this project during the warm season might help for ventilating and perhaps for reducing cure time. The kit I bought was supposed to be white, but the final product has a distinct yellowish off-white color.
December 13, 2012