Rated 4.5 out of 5 by 15
Rated 5.0 out of 5.0 by InArlington Well Made
Well made. Nice finish and easy to install. Good quality overall.
August 23, 2016
Rated 5.0 out of 5.0 by FrankfortGuy Good Fan downrods
These downrods were just right for my Hunter ceiling fans, installed under a 10 foot ceiling. However, the skimpy instructions furnished (=none) did not disclose that the fan wires MUST be inserted before putting the top end and crossbar into the downrod.. They match my brushed-nickel fans.
August 23, 2016
Rated 5.0 out of 5.0 by RA12 Does exactly what it is supposed to
As downrods go - this one is excellent - matches the fan and happy with the purchase.
May 17, 2016
Rated 3.0 out of 5.0 by Joe Not a great fit.
Was not a direct fit to the Hampton Bay Ceiling fans which I purchased from the store. I had to take the hardware off the short downrod from Hampton Bay (which is standard practice) and place it on this downrod but the ground wire lead screw size was different. Had to go back to the store to purchase #8-32 x 1/2 in Stainless Machine screws to place the ground wire to this pipe. But I also found that the metal dowel, which is supposed to support the weight of the fan, did not fit flush with the plastic end piece as it did on the Hampton Bay downrod. Instead the metal dowel was recessed into the plastic piece due to the location of the holes for the metal dowel. On top of this the holes for the ground wire and the "set" screw did not line up correctly and I had to modify the plastic piece to make it work. In short the metal dowel is not supporting the weight of the fan, the single #8-12 screw is. It looks good and appears sturdy but I have serious doubts it will last given there is but a single screw keeping it tight. Once it fails it will fall about an 1/8" to the metal dowel (remember it wasn't flush) which will hold it but will be loose and likely have a small wobble. Perhaps its morbid curiosity but I left it up anyway, maybe just to see if I'm wrong. Or maybe I'm just that stupid. I put up two of them!
P.S. If the store had them, I would have returned the generic and picked up a Hampton Bay brand at the time I went to pick up the screws.
February 29, 2016
Rated 5.0 out of 5.0 by FRED Worked as expected
Downrod was what I was looking for and it worked perfect.
December 12, 2015
Rated 5.0 out of 5.0 by StephanMark Perfect match
Just as described. Quality Hunter accessory for my Hunter fan.
September 8, 2015
Rated 4.0 out of 5.0 by Georg Universal down rod 18"
I've seen nicer finishes. Convenience was a big factor.
August 18, 2015
Rated 4.0 out of 5.0 by Sc54 Nice looking downrod
I used this when installing a Hampton bay 44 inch ceiling fan. It would have been nice to have some installation instructions included with the downrod. Did not need a threaded end but it was compatible and I was able to use it with Hampton bay fan. Looks very nice with fan.
June 14, 2015