Rated 4.4 out of 5 by 16
Rated 5.0 out of 5.0 by Susu Loved this product.
This worked well to lower our fans to the correct length
February 10, 2016
Rated 5.0 out of 5.0 by ABQUpde 36" Brushed Nickel Downrod
The down rod for the new ceiling fan was very simple to install and looks great. I also ordered the down rod and other items online and that process was very easy and I got all of my items quickly and best of all, nothing was damaged.
May 8, 2015
Rated 5.0 out of 5.0 by Homebrew Just what I needed
The rod was exactly what I needed to extend the fan I got from Home Depot
December 22, 2015
Rated 5.0 out of 5.0 by Lani Rod
Was perfect. Have a vaulted ceiling. This did the job to lower the ceiling fan.
December 15, 2015
Rated 4.0 out of 5.0 by Joe Made our fans more useful.
We had purchased two Hampton Bay fans for our dining room and living room in our home in Haiti (where fans are almost a must!). After they were shipped via container, I realized we would need longer downrods due to the vaulted ceilings in those rooms. After getting some good help from the online chat section of Home Depot, I had two three foot rods shipped down, and they are working well, even though I had to use some creative ingenuity to mount them on the angled ceiling. The fans move plenty of air and the LED lights provide lots of light without the worry of replacing bulbs all the time. The longer downrods help get the fans low enough to do the most good.
August 25, 2015
Rated 2.0 out of 5.0 by waslost1 Rusted
Wish I would have gone into the store to buy this. The one they sent was rusty on the end. Luckily, I was able to cut off about 3 inches where it was rusted. I didn't have the time or desire to return it. Other than the rust, it was fine and did the job.
October 20, 2015
Rated 5.0 out of 5.0 by DIY It's a downrod!
Fit my ceiling fan and put it at the right height. Color matched as well, but then again, I also bought a Hunter ceiling fan, so it better!
June 29, 2015
Rated 3.0 out of 5.0 by johnnyc almost perfect
Works well, however the ground screw threaded hole doesn't fit standard group screws.
April 8, 2015