Rated 4.0 out of 5 by 21
Rated 2.0 out of 5.0 by jon1000 Showed up with Big Air Leak
Product performs well, but leaks air continuously from a fitting. We tried to tighten to no avail. This shows poor quality control on the manufacturer's end. Not a giant issue, but I still need to get a service person out to fix a brand new product. Not happy.
January 2, 2014
Rated 5.0 out of 5.0 by Matt1985 Great Product
I have to say a bit sceptical I was when i decided to buy this compressor ,but after the purchase i am glad i spent the money .This thing is a beast,it supplies enough air to run my da sander for hours at a time with breaks enough to change paper without a problem.I love it and I will recommend my friends get one.I seriously dont think it can run out of air.
February 11, 2007
Rated 4.0 out of 5.0 by hook i,m happy
this product save you time and money and it has the power you need for most home garage uses.i can run my inpact wrench with constant 90 psi and it doesn't lose power,even when holding the trigger continuously for several minutes.i even use this compressor for my larger sand blaster and it holds up just fine,and that uses a lot of air.this compressor is very quiet from the one i had before and it's very easy to hook up and maintain.
September 28, 2006
Rated 1.0 out of 5.0 by Jhart Spend Your Money On Something Else
Junk plain and simple. Had to repair it the day it was delivered. A small hose was cheaply connected, but was easy to repair. Two months later the input line into the tank cracked and blew off. It was made of cheap aluminum. The next thing to go was the electric motor. This was after 6 months of light use and the correct amount of voltage to the unit. When I contacted HD to get warranty info they just sent me to Campbell Hausfeld. CH was nearly impossible to reach on the phone. I finally talked to a guy in my area(which I found on my own) that was a warranty center for CH and he said it could be up to a month before anything was repaired. Bottom line is save your money and buy an Ignersol Rand and be done.I ended up just buying another brand motor made in Ohio for $350.00. I could have bought a IR and not have had to work on anything. You may get a warranty but it is meant to be a pain so they don't have to warranty it. Cheaper is not always cheaper.
March 13, 2014
Rated 5.0 out of 5.0 by mikey73096 excellent air compressor
thanks to home depot for the sale of this compressor,it is by far the best investment i have made in a long time.i have actually seen a decrease in my electric utility bill by replacing my old compressor.this unit is extremely quiter than my old compressor.it stays consistent and has never failed me.i would never own another brand other than husky and the employees are always great to deal with.thanks again home depot.
October 15, 2006
Rated 1.0 out of 5.0 by SUPbuilder Watch out for cheap aluminum tubing!
Look at the picture of this unit. See that copper tube connecting the motor to the tank? On newer models that has been switched to aluminum tubing as a cost-saving measure. Ours sheared off after one month of commercial use. Looking at the broken tubing, it was incredibly cheap and flimsy feeling for commercial grade. Luckily we had our old compressor still and were able to scavenge the copper tube from it. This is a strong compressor otherwise. If you purchase one, and see that aluminum tubing, start looking for a copper replacement piece because it will not hold up to steady usage.
October 1, 2014
Rated 5.0 out of 5.0 by CRUZ54 EXCELLENT COMPRESSOR A+++++
1ST DAY RAN IT FOR 5 AND 1/2 HOURS STRAIGHT WORKING MY SAND BLASTER, COULD NOT BE HAPPIER WITH THIS PRODUCT WOULD RECOMMEND . BEST COMPRESSOR I HAVE EVER OWNED. IF IT HANDLED 5 AND 1/2 HOURS THE 1ST DAY, WHAT WON'T IT HANDLE
June 17, 2011
Rated 4.0 out of 5.0 by Hamza Work Horse
This unit has out performed my expectations. It is currently running 10+ pneumatic air guns and 2 production lines for 50+ hours a week.
The breakdowns I’ve had are: (1) The vibrations caused the air lines to rub against the safety net covering pulleys that caused holes and; (2) valves broke down after 3-4 years of non-stop use. These issues weren’t significant and were remedied by a quick trip to the hardware store.
Stay on top of the maintenance and you won't be disappointed.
October 15, 2013