Rated 2.8 out of 5 by 13
Rated 1.0 out of 5.0 by Debbie poor design
Won't fit in 3/8" drill--returning. What where they thinking?
September 3, 2016
Rated 5.0 out of 5.0 by Bruce Greeeeaaaaaaattttttt.
Nice price for a nice tool. Cheaper than most, but well made. Did a very good job of mixing. Not to hard to clean up. Fit my cheap battery powered drill with no problem. Definitely would recommend and purchase again.
July 23, 2016
Rated 5.0 out of 5.0 by Bayview Worked for me
I used this stirrer for sand mix driveway sealer in 5 gallon pails.
It and it worked well with no issues.
I used it with a DeWalt 1/2" 14V cordless drill and it had no problem mixing the sealer.
July 3, 2016
Rated 1.0 out of 5.0 by Evan Don't buy a 3/8 in. mixer because it's NOT 3/8 in.!!!!!
Can't believe I even have to waste my time writing this...you would think companies took specific measurements of their products so that they are accurate.
The 3/8 mixer is welded with great quality, especially for the price. I purchased a 3/8 clutch drill along with it as I need to mix large amounts of paint and clay. The mixer bit diameter is only about 1/2-1 mm off from 3/8 in., but because of this, it doesn't even fit into the drill head. I even filed down the end so it would fit easier, no luck. No customer should have to modify a tool, especially when it says the specs. right on this website. Very displeased, and both will be refunded tomorrow.
January 10, 2014
Rated 1.0 out of 5.0 by jessie Doesn't fit 3/8 chuck
I agree completely with everyone else - this DOES NOT fit a 3/8 drill - I have 2 drills and it doesn't fit either - returning it today.
If you are need of one of these I suggest you take it over to the tool section and see if it fits their 3/8 drills before you buy it.
It's a pain having to go back and return this type of item
April 8, 2015
Rated 1.0 out of 5.0 by BrianWestChest Returning mine to the store - won't fit in my drill chuck
I tried it in both of my ⅜" chuck drills. It won't fit.
April 29, 2014
Rated 1.0 out of 5.0 by JPearce Pay more for better product.
You get what you pay for. The spot welds that connect the fins to the shaft are insufficient to say the least. The one I bought didn't even survive the trip home without breaking loose. I didn't bother taking it back to the store for another one just as poorly made. If you feel like welding it back up like I did, it'll work fine.
May 1, 2012
Rated 5.0 out of 5.0 by WilsonConstruction great mixer
Even though the other reviwes are negative I have nothing bad to say about this mixer. I have two and most recently used one to mix 70 bags of type S mortar with zero problems. In fact I like it better than other traditional paddles that are cheap and brittle (this one is steel) and it doesn't shave pieces of the bucket into the mix either.
May 11, 2012