Rated 4.8 out of 5 by 4
Rated 5.0 out of 5.0 by quality1 Very Good Torx Drive Bit Sockets
Husky is a product line that is very familiar with since purchasing their box wrenches and sockets about 58 years ago of which are still in use today. Husky products were then made in USA. However these sockets are made in China.
Overall, they were well made and made removing and installing vehicle cabin air filter fasteners easy. The only issue encountered was that the shank appeared to be longer when compared to "loose" Torx bits used with a corresponding drive socket. In short these did the job and are recommended.
However, Husky may wish to consider furnishing a Torx kit that has both long shaft sized bits (5-6") similar to a screw driver shaft length and including these that can be used with a power rachet. There appears to be very few all inclusive kits available on the market and that is the reason for the suggestion.
August 28, 2016
Rated 5.0 out of 5.0 by NHpro Quality Product
These torx bits work just fine and are very high quality. I rely on my tools to perform winter, spring, summer and fall and hate to purchase a tool that just doesn't measure up over the long haul. These bits are tools I can count on when needed. There isn't much to these other than the ratchet connection and extension to reach those difficult screws.
Enjoy these tools for many many years.
August 24, 2016
Rated 4.0 out of 5.0 by fred a excellent tool addition
If you are like me a wood worker and sometimes a repair man. These type of bit that is a 1/4 in. drive works very good in tough times needing to reach back into something to remove a torx drive screw from a appliance that you are trying to repair. I use the bit with a 1/4 in drive extension sometimes with my ratchet or on my impact drill depending on the need
September 4, 2016
Rated 5.0 out of 5.0 by porchguy Good tools and a good value
These sockets seem to be very good quality. I don't know how well they'll hold up over time but they look and feel to be very well made of good quality material.
I like the fit of the sockets both on my 1/4 drive rachet and in the screw heads. They fit easily, no fiddling around, but not a sloppy fit at all. I've even tried putting a bit of extra pressure on the socket and tilting it a bit in the screw head at the same time and it didn't cam out or slip.
I like it.
August 23, 2016