Rated 4.3 out of 5 by 24
Rated 1.0 out of 5.0 by ElenaLor Flimsier than any tool I've ever seen
Low price is not value if a product is not fit for its intended purpose. Needed to remove seat belts to take out rear interior panel in a Ford truck. At first attempt this bit broke leaving a piece stuck in the bolt's head. Thankfully Dremel saved the day and I got it out but complicated a simple job. Keep in mind I'm no big strong man: 50 years old woman, with artritis and a 24" ratchet. Had to wait until next day to buy from Snap On: bit worked like a charm (bolt was fine, not rusted, perfect thread). Brittle like no tool I've ever used.
October 24, 2015
Rated 5.0 out of 5.0 by Bill Worked to remove seatbelt bolts from 1996 Sonoma
Worked to remove seatbelt bolts from 1996 GMC Sonoma. Didn't chip/break but didn't a ton of torque to turn the bolts anyways.
December 16, 2015
Rated 5.0 out of 5.0 by Mark Great tool , lifetime warranty for under $2
These are just little tools, do not tighten to 80ftlb!!! obviously Its going to break! 80inlb is no problem, ive compared them to craftsman/ mac tool and snapon they all break or bend at the same point but at a 10th of the price with lifetime warranty you can not go wrong!
July 28, 2016
Rated 5.0 out of 5.0 by JustCallBen Did the job
Nothing to write home about. I had some stuck vehicle seat bolts and this tool did the job.
May 3, 2016
Rated 4.0 out of 5.0 by PeakRider Good product, good price, easy pickup at store
Needed this to change the shocks on the hatchback on my Jeep Grand Cherokee. Just needed this tool for this job, probably won't use this tool again. Price was great, and easy pickup at the store on my way home from work.
December 29, 2015
Rated 1.0 out of 5.0 by Bob Junk...
First time I used this piece of junk, a spline sheared off. Was attempting to apply 80 ft. lbs. with a torque wrench when it happened. Consider yourself warned; don't buy Husky junk... ;+(
December 12, 2015
Rated 5.0 out of 5.0 by Maks Nice little bit
This little T25 bit worked perfectly with my impact driver and adapter (to fit onto a 1/2 in. driver). I work with torx screws a lot and this drive pattern or square grip the best, while phillips bits typically strip or break easy due to their design, which is why the former are preferred in concrete, decking, and other high strength applications, especially when working with impact tools. Torx are also commonly found on some cars and motorsports vehicles; it's one of those things you never know you'll need until you get there. I have never seen a torx bit break before, and am not expecting to either. I was able to put 4 inch decking screws through lumber without any wear or stripping on the bit. Husky is a good brand, and even though the quality might cost you a little more, it's worth it. . . imagine being on a job and having the bit break on you and not having any extras laying around. I have had this happen with drill bits and philips bits, and it really sucks when you have to run to the store for a stupid little thing that's holding back your project and having guys wait on you.
August 31, 2016
Rated 5.0 out of 5.0 by mttaylor1066 Well-built and does the job
I needed this particular size socket to change spark plugs in my Honda Odyssey. I didn't need a full set so this fit the bill. Solidly built and does the job.
October 20, 2015