Rated 4.2 out of 5 by 13
Rated 5.0 out of 5.0 by Radek Cuts with and without the Water
I used it to cut 3/4" thick quartz, which is easy to cut stone. I don't have experience with stone cutting. I can't compare this blade with any others. But I am pleased with the results. Cutting was easy and fairly fast. I encountered no problems even though I am total novice in stone cutting.
July 19, 2016
Rated 5.0 out of 5.0 by don Gas stove installation.
Found that corian counter top opening was too small for new stove. Used King Diamond grinder blade to cut 1/4" off of each side. Had never done this type of cutting before. Cutter blade worked beautifully. Home Depot manager who recommended it was excellent also.
October 18, 2016
Rated 5.0 out of 5.0 by BobBob Clean cuts
Needed to cut 1.2" thick granite countertop on three sides to accept a slip in range. About 7' of cutting. Cut cleanly with minor chipping that a sander removed. performed better than I expecteD and I saved $120 for 30 minutes work.
August 24, 2016
Rated 1.0 out of 5.0 by Ben Diamond blade
Was out of round and broke every tile. I purchased to avoid having to use my big saw for a small job. Waist of time and money.
April 5, 2016
Rated 1.0 out of 5.0 by cl Diamond blade
Did not cut tile well, I was told it would cut like butter by the sales rep, however this blade was very rough and caused significant chipping. I wasn't sure if I had porcelain or ceramic, rep said it didn't matter.
March 1, 2016
Rated 4.0 out of 5.0 by DIYinUT worked like a charm
This worked really well for cutting notches into tiles to go around door frames and heat registers. there were no issues on its performance.
the one issue I had with this blade is that the thickness of the center of the blade was a little too thin for my dewalt cordless angle grinder. I set this in place and after about 15 seconds of cutting the wheel started to wobble. I removed the chuck/nut on my drinder and found that the inner brass insert on the wheel had come out and was starting to fail. I had to turn the chuck opposite of the orientation stamped into it for this to work and fit on my dewalt. though after doing this I had zero issues with cutting notches into 12"
December 23, 2014
Rated 5.0 out of 5.0 by Dave Worked fine
Fit my saw and worked properly with no complaints.
August 18, 2015
Rated 4.0 out of 5.0 by Ic Tile blade
Cuts like a champ. Helped me lay 250sqft while redoing the bathroom.
July 7, 2015