Rated 3.9 out of 5 by 51
Rated 1.0 out of 5.0 by Dc Poor quality
Don't waste your money on this blade. It lasted 10 cuts before it was dull. I ended up putting old blade back on to finish my cuts.
August 17, 2016
Rated 5.0 out of 5.0 by LDE66 Good quality tile saw.
I recently installed ceramic tile in my kitchen, dining nook, hallway and laundry area, about 250 square feet in total. I installed 13 inch tiles. With a number of cabinets, cut-out areas for stove, refrigerator, dishwasher plus a food pantry and the the laundry area, there were numerous cuts that needed to be made. From start to finish, the blade performed flawlessly. There were some cut edges that were exposed that needed to be chip-free and very smooth. This blade was able to make those cuts easily. Of course you have to have a decent-quality saw and you can't rush through the cutting process...slow and steady will provide an excellent cut every time.
November 12, 2015
Rated 2.0 out of 5.0 by housefixer Not smooth cut
I bought this 7 inch blade for use on a QSP table tile cutter for cutting 12 x 12 1/4 inch porcelain tile. While the blade did adequately cut the tile, it left a jagged edge which is too sloppy for a shower or tub.
August 2, 2016
Rated 4.0 out of 5.0 by bigdog tile blade
great for the part time user. had to use vice grips to remove old blade and install new
July 21, 2016
Rated 1.0 out of 5.0 by Honeydoer Worse than old worn blade...
This blade was bad from first cut. Cut rough and split the first two porcelain tiles used on. Replaced with old blade until better quality blade purchased.
May 29, 2016
Rated 4.0 out of 5.0 by nickname went a long way
I did about 3000 sq ft of tile floor had to use 2 blades. Even when it gets old doesn't chip edges bad. but when new is like factory cut.
May 17, 2016
Rated 5.0 out of 5.0 by emoye 5
Blade is sharp giving the tile a nice smooth edge-5
April 12, 2016
Rated 5.0 out of 5.0 by gman clean cuts no chips.
Worked as expected, used on ceramic tile. Upgrade over previous blade.
March 20, 2016