0650531125675

Suggested Replacement

20,000-Watt Air Cooled Standby Generator with 200 Amp Service Entrance Rated Automatic Transfer Switch and Load Shed Kit
  • KOHLER
  • Model 20RESAL-200SELS
  • Internet # 205816039

20,000-Watt Air Cooled Standby Generator with 200 Amp Service Entrance Rated Automatic Transfer Switch and Load Shed Kit

Compare to Discontinued Model View Product

Discontinued Model

Discontinued

KOHLER

Model 20RESAL-SE

Internet #205216697

20,000-Watt Air Cooled Standby Generator with Automatic Transfer Switch and Load Shed Kit

This item has been discontinued.
The Home Depot no longer carries this specific product.

Frequently Bought Together

Product Overview

Whether you’re home or away, your KOHLER Generator will automatically kick in whenever the power goes out. Restoring power in as little as 10 seconds, KOHLER Generators have extraordinary reliability and quiet operation - similar to a central air conditioner. KOHLER backs each generator with a 5-year/2,000-hour limited warranty. From our first generator in 1920 to our bold new lineup now, KOHLER Generators are a trusted brand by hospitals, airports and the National Weather Service and Home Depot stores nationwide.

  • Includes: KOHLER 20,000-Watt generator, 200-Amp SE, indoor/outdoor load-shedding transfer switch, integrated mounting pad, flexible fuel line and easy connection terminal block
  • Commercial grade engine - KOHLER Command PRO engine designed for heavy-duty applications far exceeding the demands of a standby generator
  • Premium power quality - +/-1%-Voltage regulation and less than 5% harmonic distortion protects your most sophisticated electronics from damage
  • Powerful performance- exclusive Power boost technology allows you to run central air and other large appliances all at the same time (based on generator and load size)
  • Fast response - automatically restores power in as little as 10 seconds
  • Quiet operation - low decibel levels similar to central air unit and rated according to EGSA (electrical generating systems association) standards
  • Corrosion-proof enclosure - protection from even the harshest conditions
  • Premium warranty - 5-year/2,000-hour limited warranty
  • No refueling - runs on your home’s natural gas (NG) or liquid propane (LPG)
  • Built in load shedding, Additional accessories available: maintenance kit (# 202022473), carburetor heater (# 203269644) and fuel regulator heater (# 204080650)
  • Remote monitoring-optional OnCue plus or OnCue plus wireless remote monitoring system gives you control and communication with your KOHLER Generator from anywhere in the world - without a cellular contract or poor reception (see Home Depot item #205104528 and #205467676)
  • Installation and local permitting charges are not included, To locate an authorized KOHLER installer, please call 1-800-717-2565, Group 51 battery sold separately

Info & Guides

You will need Adobe® Acrobat® Reader to view PDF documents.  Download a free copy from the Adobe Web site.

Specifications

Dimensions

Details

Warranty / Certifications

More Products With These Features

Search

Customer Questions & Answers

9 Questions18 Answers

Customer Questions & Answers

20,000-Watt Air Cooled Standby Generator with Automatic Transfer Switch and Load Shed Kit
20,000-Watt Air Cooled Standby Generator with Automatic Transfer Switch and Load Shed Kit

Ask your questions. Share your answers.

 
 
Clear Search Term
 
 
Sort By:
 
3 answers

What size and type of battery should be ordered for this generator?

This question is from 20,000-Watt Air Cooled Standby Generator with Automatic Transfer Switch and Load Shed Kit
Asked by
Green Cove Springs, Fl
Read all my Q&A
January 19, 2015
0points
0out of 0found this question helpful.
Was this helpful?helpful0unhelpful0

Answers (3)

Asked by
Aitkin Mn
Read all my Q&A
February 25, 2015
Answer: 
It list a battery that is of 550 cca (cold cranking amp) but the battery class is 50 good luck at finding that class at a farm and fleet . I found one at fleet farm in mn that has 600 cca for 68.00 that fits into the opening otherwise i can get at and auto parts place for 120.00
0points
0out of 0found this answer helpful.
Was this helpful?helpful0unhelpful0

Asked by
Waukegan, IL, USA
Read all my Q&A
Home Improvement Profile: Professional
January 21, 2015
Answer: 
Kohler recomends a 12 volt group 51 complying with SAE J-537
dimensions are 9.4" L x 5.1" W x 8.8" H
500 starting amps @ 0 deg F
0points
0out of 0found this answer helpful.
Was this helpful?helpful0unhelpful0

January 20, 2015
Answer: 
Hello, my name is April with KOHLER Customer Service. I am happy to assist you with your generator question.
For the Model # 20RESAL-SE requires a Group Size 51, 500 Cold Cranking Amp, 12V Battery. Please work with your local Home Depot for pricing and availability on this product.
Thank you for choosing the Bold Look of KOHLER.
0points
0out of 0found this answer helpful.
Was this helpful?helpful0unhelpful0
 
2 answers

Does Home Deport have recommended local contractors for installation?

This question is from 20,000-Watt Air Cooled Standby Generator with Automatic Transfer Switch and Load Shed Kit
Asked by
Aiken, SC
Read all my Q&A
September 12, 2014
0points
0out of 0found this question helpful.
Was this helpful?helpful0unhelpful0

Answers (2)

Asked by
Pueblo West, CO
Read all my Q&A
October 7, 2014
Answer: 
Home Depot does not, but prior to delivery, the manufacturer will send you a listing of licensed installers in your area. I'd recommend you use one of them to do the wiring, as they are quite familiar with the unit, and will check all the safety items and fire it up for testing if you have the gas in place and connected. Also, if you use their installer, the warranty will not start until he fires it up Read More
Home Depot does not, but prior to delivery, the manufacturer will send you a listing of licensed installers in your area. I'd recommend you use one of them to do the wiring, as they are quite familiar with the unit, and will check all the safety items and fire it up for testing if you have the gas in place and connected. Also, if you use their installer, the warranty will not start until he fires it up and tests it. Read Less
0points
0out of 0found this answer helpful.
Was this helpful?helpful0unhelpful0

Asked by
KohlerCo.
Read all my Q&A
Home Improvement Profile: Other
September 12, 2014
Answer: 
Hello, my name is Elissa with KOHLER Customer Service. I am happy to assist you with your Generator question.
I am sorry I am not able to provide suggested local contractors for your installation of the Model # 20RESAL-SE. For a list of local contractors please work with your local Home Depot Store.
Thank you for choosing the Bold Look of KOHLER.
0points
0out of 0found this answer helpful.
Was this helpful?helpful0unhelpful0
 
2 answers

How much is instalation ?

This question is from 20,000-Watt Air Cooled Standby Generator with Automatic Transfer Switch and Load Shed Kit
Asked by
Read all my Q&A
September 10, 2014
0points
0out of 0found this question helpful.
Was this helpful?helpful0unhelpful0

Answers (2)

Asked by
Pueblo West, CO
Read all my Q&A
October 7, 2014
Answer: 
That will vary depending on labor rates in your area, distance for the installer to travel, costs of permits, etc. In my case, it ran around $960, but I have mine mounted very close to the house breaker panel, so the installer didn't have to supply much wire, do a lot of routing, etc. Keep that in mind while planning your installation. You'll want it as close to the house, and the area where your Read More
That will vary depending on labor rates in your area, distance for the installer to travel, costs of permits, etc. In my case, it ran around $960, but I have mine mounted very close to the house breaker panel, so the installer didn't have to supply much wire, do a lot of routing, etc. Keep that in mind while planning your installation. You'll want it as close to the house, and the area where your electrical service enters the house, as possible. Put it out in the north 40, and it'll cost you a chunk. Gas hookup will vary, as well. My home is on natural gas, but I put in a propane tank so as to have power in the event that gas service is interrupted. I was able to buy a used tank and mount it near the generator pad, so they only had to ditch about ten feet to bury the fuel line. Also, output on propane is about 2K greater than the engine will allow on natural gas. Read Less
0points
0out of 0found this answer helpful.
Was this helpful?helpful0unhelpful0

Asked by
KohlerCo.
Read all my Q&A
Home Improvement Profile: Other
September 11, 2014
Answer: 
Hello, my name is Justine with KOHLER Customer Service. I am happy to assist you with your generator question.
I apologize but for Installation and local permitting charges you will need to locate an authorized KOHLER installer, please call 1-800-717-2565.
Thank you for your inquiry and choosing the Bold Look of KOHLER.
0points
0out of 0found this answer helpful.
Was this helpful?helpful0unhelpful0
 
2 answers

I just ordered this system. If the transfer switch is not a 200A service rated unit, can I upgrade to 200A service rated at an extra cost? Thanks.

This question is from 20,000-Watt Air Cooled Standby Generator with Automatic Transfer Switch and Load Shed Kit
Asked by
Gettysburg, PA
Read all my Q&A
August 27, 2014
The online literature suggest the 20RESAL is available with either the 100A RXT ATS with a 16 space load center for indoor installation or the service entrance rated 200A RXT ATS. I need the 200A version. If the unit comes standard with the 100A, can I upgrade to the 200A at an extra cost? Thanks!
0points
0out of 0found this question helpful.
Was this helpful?helpful0unhelpful0

Answers (2)

Asked by
Pueblo West, CO
Read all my Q&A
October 7, 2014
Answer: 
The transfer switch is rated for 200 amps on the indoor installation. At least, that's what came with mine.
+1point
1out of 1found this answer helpful.
Was this helpful?helpful1unhelpful0

Asked by
KohlerCo.
Read all my Q&A
Home Improvement Profile: Other
August 28, 2014
Answer: 
Hello, my name is Justine with KOHLER Customer Service. I am happy to assist you with your Generator question.
According to the information provided the 20,000-Watt Air Cooled Standby Generator with Automatic Transfer Switch and Load Shed Kit model number 20RESAL-SE this unit comes with a 200amp service entrance rated switch.
For additional assistance on this inquiry, please contact our Customer Care Read More
Hello, my name is Justine with KOHLER Customer Service. I am happy to assist you with your Generator question.
According to the information provided the 20,000-Watt Air Cooled Standby Generator with Automatic Transfer Switch and Load Shed Kit model number 20RESAL-SE this unit comes with a 200amp service entrance rated switch.
For additional assistance on this inquiry, please contact our Customer Care Center at 1-800-4KOHLER. (1-800-456-4537)
Thank you for your inquiry and choosing the Bold Look of KOHLER. Read Less
+1point
1out of 1found this answer helpful.
Was this helpful?helpful1unhelpful0
2 »
  • 2016-08-24 T15:37:08.515-05:00
  • bvseo_lps, prod_bvqa, vn_prr_5.6
  • cp-1, bvpage1
  • co_hasquestionsanswers
  • loc_en_US, sid_205216697, prod, sort_default
2 »
  • bvseo_sdk, java_sdk, bvseo-3.1.1
  • CLOUD, getContent, 126ms
  • QUESTIONS, PRODUCT

Customer Reviews

Rated 4.5 out of 5 by 2 reviewers.
Rated 5.0 out of 5.0 by Great generator reviews from Consumer Reports Magazine Rated number 1 generator in Consumer Reports Magazine. Yes a little more money than the Generac and Ge ,but well worth the money. Kohler has been around a long time. FYI you need a kohler generator rep to do the first start up if you don't they will void warranty ,like all manufactures . If you are a good diy person and have knowledge of electrical systems you can hook this up yourself. but have a rep from your area do the start up . A start up can cost about 350 dollars My start up was 250. I have never had problem with Kohler engines . I have Kohler engines in John deere tractors an yard machines that are over 40 years old and still running strong February 25, 2015
Rated 4.0 out of 5.0 by 20kw Home Generator Installed this unit myself. Had problems with the weekly test. The unit would surge only on the weekly test. Called the factory. Took several weeks to find a dealer that would come look at the unit. I was told the problem was the fuel line. After having the propane guys test everything and it all tested good still problems with the weekly test. Both the dealer and the factory pointed at my installation and fuel line problems. So I said i will pay you to fix anything you find wrong that is causing the problem. They rerouted the fuel line.... Still the same problem with the weekly test. So i guess it was not my install after all. Now we are at 4 months later the factory came out with new controller code. Fixed the weekly test but now it surges when it starts for a power outage. Now another month has gone by. The dealer came out and did some custom codes to make it work. I was told this is required when it is cold outside. Now we wait for spring to see what happens when it is warm. Very frustrating. The unit is good but lacks a good network of dealers. Dealers only want to work on the big stuff they do not have time for us home guys. Find a local dealer first then buy what they service. No mater how good you are you still need a dealer to make custom changes to the controller code. February 25, 2015
  • 2016-08-26 T12:46:53.384-05:00
  • bvseo_lps, prod_bvrr, vn_prr_5.6
  • cp-1, bvpage1
  • co_hasreviews, tv_2, tr_2
  • loc_en_US, sid_205216697, prod, sort_default
1-2 of 2
  • bvseo_sdk, java_sdk, bvseo-3.1.1
  • CLOUD, getContent, 109ms
  • REVIEWS, PRODUCT