Rated 4.4 out of 5 by 12
Rated 5.0 out of 5.0 by Moremike08 Exactly the same fit
Easy to install and the same fit as the original product.
August 9, 2016
Rated 5.0 out of 5.0 by Michelle It is a great product and price
Unfortunately I had to replace my entire toilet because of the model Koehler I had. But was so thankful for the price of this pice and ease of returning it.
July 5, 2016
Rated 5.0 out of 5.0 by rlnipsr canister valve assembly kit
This valve assembly came complete and ready to install with a minimal amount of disassembly. It's so easy to operate now, my wife is very thankful since the old one caused pain in her hands when she pushed the lever.
Also the lady I talked to at Kohler was very helpful, great customer service!!
May 25, 2016
Rated 5.0 out of 5.0 by new2DIYworld Do not follow included instructions (unless needed!)
The included instructions are in case you need to replace the entire assembly. In my case only the valve was broken. I did not have to remove the tank to replace this. The online you tube video from Kohler shows how to replace only the valve without having to dismount the tank.
April 19, 2016
Rated 5.0 out of 5.0 by fixit2002 Good Value.....
Only used part of kit. Fit perfectly and working very well. No problems..
March 29, 2016
Rated 4.0 out of 5.0 by Bigdog Works well
Easy install - took about ten minutes. The only challenge was that it was not available in the local store and I had to order on-line. The parts arrived in a few days and job was completed.
December 22, 2015
Rated 5.0 out of 5.0 by Redpop Easy buy and pretty quick ship.
Even though I only needed to change out one of the components in this 'flush valve' kit, I did remove the toilet tank and replaced the entire assembly. This repair might be a challenge for some, but this way you wind up with a complete repair.
September 15, 2015
Rated 4.0 out of 5.0 by OldFormerHomeowner Product needs an installation tool
The large plastic nut that secures the valve to the toilet bowl is to large to be turned by any tool a homeowner is likely to have. A simple plastic collar that would slip over the nut and have sturdy lugs spaced around its circumferance would be relatively cheap and would allow the nut to be turned by striking the lugs with a hammer.
December 10, 2014