Rated 2.9 out of 5 by 105
Rated 2.0 out of 5.0 by Ed After 7 1/2 years: Stuck, major corrosion
After 7 1/2 years, this expensive Kohler faucet became very hard to rotate from one side to another. Today I pulled off its main metal structure and found pitting corrosion in several spots on the inside. Vinegar and a small screwdriver helped me remove the corrosion, revealing the pitting. In some spots the pitting is so bad it's almost breaching the outside chrome surface. I removed the corrosion material and now it's rotating freely again, but the pitting obviously stays in place and will only get worse. In 2-4 years I will have to replace it because the corrosion will finally reach the outside. I like Kohler, this was a disappointment.
July 4, 2016
Rated 4.0 out of 5.0 by BpbbyG BobbyG
Clean lines easy operatipn,ask iin ten years if it still works and is still shiny
July 26, 2016
Rated 5.0 out of 5.0 by 2Rubyslippers Great product, easy installation
This is a replacement for the exact same faucet only the updated model. Works great, looks good, although the water pressure seems a bit weak.
January 19, 2016
Rated 5.0 out of 5.0 by Spray15 The Best faucet
I was very pleased that the installation was not difficult and I spent more time removing the old faucet. The quality is what I expected from Kohler a great value.
January 19, 2016
Rated 2.0 out of 5.0 by Daddo0711 Should be much better than it is
Wisconsin native trying to be proud of the company. As many others have written I spent a bit of extra money to get the Kohler reputation for quality. It functioned well for about a year and then started to deteriorate. With the exceptionally high calcium content of our water the switch to go from steam to spray became very difficult to fully engage either way. You'd be left with a weak spray centered by a trickle of stream, or a fair stream with a ring of weak spray. Then at about 3 years it became increasingly hard to swivel the faucet to either side. At the end it was locked to the left. I was applying as much pressure as I dared with absolutely no results. When I pulled the entire faucet out I found a fairly cheap plastic collar separating the body of the faucet form the escutcheon plate (see pic). It had become encrusted with sediment and could not be removed.
To their credit Kohler customer service, with very few questions, sent me free of charge an entirely new faucet citing a "manufacturing defect" as the mode of failure. Though I appreciate it I have little doubt this will be happening again in a relatively short time and am not looking forward to replacing the faucet every few years.
As a nitpick, the rubber seal between the escutcheon plate and sink does not work well. By itself it would do little to seal itself, and even with the addition of plumbers putty there was still plenty of gunk built up under it.
October 19, 2012
Rated 1.0 out of 5.0 by bp Poor quality
I've owned this faucet for about 5 years and I can't fix it anymore. Just after the first year the plastic button broke off. By the 2nd or 3rd year the handle broke off. It occasionally drips after being turned off. The handle broke off yet again so I'll be throwing in the towel on this one and get a better quality product.
September 9, 2015
Rated 1.0 out of 5.0 by Eric Very disappointed. Not the quality I expect from Kohler.
Purchased in 2012, four years later, many issues:
1) The button (switches between stream and spray) fell off.
2) Hose is leaking. (Of course, I didn't realize that for who know how long. Now, the area under the sink is water damaged.)
3) The bonnet is no longer threaded into the base of the faucet.
For the price of this faucet. I would expect much better performance.
April 19, 2016
Rated 3.0 out of 5.0 by ShiShi Difficult to Maintain Properly Working Kitchen Faucet
I have had a number of problems with this Kohler product K-10433. Not sure how to handle them. The plastic buttons on the sides of the pull-out sprinkler have broken and have had to be replaced. The direction, even with new buttons, is difficult to get to divert. I have replaced the cartridge and it seems to work. The whole faucet tends to bind when pushed to either side to get from one sink to the other one adjacent to it. Not sure why and have placed lubricant that works for a while. Not sure if some kind of calcium build-up that needs repeated servicing or whether lubricant isn't working. It should move smoothly, but doesn't. Appearance is fine. Maybe suggest polished chrome instead of brushed nickel since easier to care for. It concerns me that this has required an excess of time to keep running.
July 20, 2016