Model # 36099

Internet #203491781

Store SKU #411889

Latex-ite Pli-Stix 60 ft. Small Black Driveway Crack and Joint Filler
0090932360990

Latex-ite

Pli-Stix 60 ft. Small Black Driveway Crack and Joint Filler

  • Fill your blacktop cracks & joints permanently
  • Lifetime Guarantee
  • Just pack and melt
$14.98 /each

Frequently Bought Together

Product Overview

Latex-ite Pli-Stix 60 ft. Driveway Crack and Joint Filler - Small Black is a contractor-grade thermo-plastic rubber designed for use with a propane torch or heat gun. It is a permanent, patented, self-leveling seal for small asphalt and concrete cracks. This product produces a 100% watertight seal.

  • Fills asphalt and concrete cracks or expansion-joint cracks 1/4 in. to 1/2 in. diameter
  • Hot-applied rope-like filler bonds to sidewalls for a permanent seal
  • Traffic ready in approximately 20 minutes
  • No volatile organic compounds
  • For deep cracks or joints, before you begin fill the crack using backer rod, sand, or stone dust but leave enough room for product

Info & Guides

You will need Adobe® Acrobat® Reader to view PDF documents.  Download a free copy from the Adobe Web site.

Specifications

Dimensions

Details

Warranty / Certifications

More Products With These Features

Search

Customer Questions & Answers

Can this be used to seal the edges of a blacktop patch?

Asked by: MasonMax
Yes, if you can get the material in the seam between the new and old asphalt.
Answered by: Customer Support
Date published: 2016-12-20

how much does it weigh

Asked by: erwin
The entire roll of the "rope" is about a pound and a half, I guess - never weighed it actually, quite comfortable to handle when working with it.
Answered by: v2015
Date published: 2015-09-20

Does this product dry black

Asked by: Roy
Yes.
Answered by: Customer Support
Date published: 2016-10-17

Can I use a heat gun to melt this?

Asked by: GT
Don't know if a heat gun would generate the high temp needed to melt the filler. I used a handheld torch, and the filler melted and started to drip in seconds.
Answered by: Weekender
Date published: 2016-07-10

"Small" vs "medium" both say 1/4 to 1/2 inch cracks, but "small" is 60 feet and "medium" is 30 feet. Is small for a different size range than medium?

Asked by: JK
I ordered the small which was easier to fit into smaller portions of the crack. I just doubled it up for the wider portions. I could have used 1.3 medium and half small but would've had material left over.
Answered by: HandyAndy
Date published: 2016-10-07

How long do I need to wait after using this product, to reseal the driveway with sealer ?

Asked by: Wrunkle
I let it set up over night. In addition, I also feel it's best to apply it in warm temperatures.
Answered by: Stu
Date published: 2016-10-06
  • y_2017, m_2, d_15, h_20CST
  • bvseo_bulk, prod_bvqa, vn_bulk_0.0
  • cp_1, bvpage1
  • co_hasquestionsanswers, tq_6
  • loc_, sid_203491781, prod, sort_[]
  • clientName_homedepot
  • bvseo_sdk, java_sdk, bvseo-3.1.1
  • CLOUD, getContent, 59ms
  • QUESTIONS, PRODUCT

Customer Reviews

Pli-Stix 60 ft. Small Black Driveway Crack and Joint Filler is rated 4.5 out of 5 by 65.
Rated 5 out of 5 by from Pli·Stix:Easy to use and works as described. The product fills small to medium size cracks in an asphalt driveway easily. You can use scissors to trim its length and thickness as needed. A little gasoline or petroleum based solvent will clean any asphalt residue from the surface of the scissors. It works best if the product can be forced into the crack before heating it. If placed on the surface of a crack, as it is heated it will deform and may move from the spot where you put it. If you try to push it back with any object, it will stick to that object. Also if placed on top of the crack, it may flow a bit beyond the crack onto other areas of asphalt. This will not work on sloping areas of asphalt for the same reason. The directions assume you will push the crack filler into the crack as this is the best method for producing good results.
Date published: 2016-10-04
Rated 5 out of 5 by from Sealed the cracks to stop the frost making them expand I have been maintaining this driveway for 25 years, need to reseal every 3-4 years. This product seals the cracks well, see puddle in photo. If you attach your propane torch to a ten inch long 2x4, you can keep the touch aligned to the crack and move quickly down a crack with a little practice. I use a knee pads home depot bucket/seat (hold the tools) to support my chest as I work the cracks. I do not seal the drive, just maintain the cracks, which every drive will have in several years.
Date published: 2016-09-27
Rated 3 out of 5 by from Too much $, for so little Snakes around when heating up way too much. I would recommend the half inch "crack-rite" "crack-stix", seems to be the value and coverage. Still all owned by Dalton. If you're having trouble with snaking or curling puncture the outer cellophane layer in spots with a utility knife or scissors.
Date published: 2016-10-05
Rated 5 out of 5 by from Tar rope worked great I had cracks forming in my asphalt driveway and wanted to seal them before winter came. Most of my cracks were too small to wedge the rope in but I used a torch and melted it into the driveway as if I were soldering. Turned out great. It surely works for my larger cracks too.
Date published: 2016-11-29
Rated 4 out of 5 by from Good product Good results but mine needed a second application the next year due to material opening up in the cracks. You may also find it helpful to apply a very little light sand while material is still hot to help the fill to blend with the rest of pavement.
Date published: 2016-09-06
Rated 4 out of 5 by from Driveway CRACK SEALER Works just as described in videos ,however should've purchased the cane to heat while standing up , would have done if price of cane was a bit Expensive so
Date published: 2016-11-01
Rated 4 out of 5 by from The stuff seems to work It was a bit thing for some of the larger cracks and the stuff smells bad. Make sure you are not breathing the fumes in. But overall seems like it worked.
Date published: 2016-10-11
Rated 3 out of 5 by from Melting plistix Love the product slow process with torch .So I melted in a metal coffee can bent can for spout and vice grips for handle worked like a charm
Date published: 2016-12-06
  • y_2017, m_2, d_16, h_3
  • bvseo_bulk, prod_bvrr, vn_bulk_0.0
  • cp_1, bvpage1
  • co_hasreviews, tv_0, tr_65
  • loc_, sid_203491781, prod, sort_[SortEntry(order=RELEVANCE, direction=DESCENDING)]
  • clientName_homedepot
  • bvseo_sdk, java_sdk, bvseo-3.1.1
  • CLOUD, getContent, 61ms
  • REVIEWS, PRODUCT