Rated 3.4 out of 5 by 74
Rated 5.0 out of 5.0 by Whitney High-end drawer slides - easy to install and purposeful
The drawer slides are very well made and slide easier than ever - quiet too! Easy to install with step by step instructions and placement
October 27, 2014
Rated 1.0 out of 5.0 by DLM Will never use again
Expecting problems, I spent a lot of extra time making sure that I built my cabinet perfectly to start with. Installed first drawer then spent about an hour trying to fine tune it before realizing that these slides just don't operate smoothly no matter what. Hard to start pull, makes loud clicking noise, do not glide smoothly opening or closing, again loud click when it hits the soft close. Directions useless. Zero tolerance, zero adjustably. These slides did not make me look very good to the customer.
October 13, 2016
Rated 4.0 out of 5.0 by Reconjack Very nice upgrade to any drawer, add on hardware isnt so great
After figuring out that I needed 22 inch soft close slides for my 18 inch drawers in the kitchen, install wasn't all that difficult. The directions are about useless as the only measurement they give that's correct is the 1 1/4" mounting of the slide to the drawer itself. The add on rear brackets needed for any face frame drawer (most any pre-built type stuff is face frame as was the run of the mill drawers I bought from Home Depot years back that these were going into), aren't very well designed. For a heavy duty slide setup like this, the brackets you are forced to buy to make it work are plastic (part D806), and the screws that come with them are all but worthless, too small in length and head size. After figuring out the proper measurements to mount them to the rear inside of my drawer housing, I used 1 5/8 inch dry wall screws that seated and held much better. The initial setup (figuring out which ones you need, vice hardware) will be a pain, but once they're installed and leveled, they work as intended even allowing the entire drawer to slide out of the cabinet itself unlike the low end slides that keep roughly 1/4 of the drawer hidden at max. As these were the only reasonable option I've found that was readily available, they are a good value and I would use them again.
June 6, 2016
Rated 3.0 out of 5.0 by Bigdan Use Rockler Rear Brackets
I purchased these and the Liberty rear brackets 'designed' for these slides. I installed everything to a T and bam, the drawer bottoms out an inch from closing. It was hitting the rear bracket. Thankfully, Liberty customer service provided me with the tech sheet, so I cross-referenced the slide with competitor brackets and the Rockler 757 series fit perfect and are flush fit. Everything now works great and I hope Kiberty sees this so they can redesign their horrible brackets, now!!!!
September 14, 2016
Rated 2.0 out of 5.0 by Rich Buy something cheaper
At $20 per set these are expensive the ball bearing slides do not slide very easily I would not waste my money on this brand again
September 6, 2016
Rated 5.0 out of 5.0 by BrianL Great Item
Installed quickly and easily. Works effortlessly to both open and soft close
August 23, 2016
Rated 4.0 out of 5.0 by Richard38 Drawer Slide
The drawer slides work fine once properly installed. Installation was difficult in my cabinets. The rails require a flat surface for installation. My cabinets were fabricated differently. They had a frame with 1/4-1/2 inch veneer glued to the frame forming the outside of the cabinet. I had to glue and screw a spacer board to the veneer to make the flat surface. After the rails were installed I then had to add cardboard shims between the rails and spacer boards to adjust the distance between the rails so the drawer would open smoothly. The rails must be attached to the drawer and inside the cabinets with precision and consistency or the drawer will not be level, slide in and out easily or close properly. The product is fine but installation was difficult and time consuming (about 4hrs per drawer.).
July 21, 2016
Rated 1.0 out of 5.0 by LinkB Quality an Issue
First, I don't know if this is a Home Depot return issue or a product issue, but 3 of the 4 pair did not come with screws. I purchased the screws detailed in the directions, but the heads pulled through the mounting holes and I had to reattach all the slides after the initial assembly (and failure).
Second, the soft close function worked initially, but after removing the slides and using the smaller holes to mount them after the screws pulled though, the soft close feature stopped working altogher. I can pull the piece of plastic on the closing mechanism forward, but it will not stay. It closes again while the drawer is still open.
Lastly, two days after installing the drawers, one side of one of the pairs simply broke apart.
In addition, I agree that the instructions were very lacking.
January 2, 2015