Rated 2.9 out of 5 by 12
Rated 1.0 out of 5.0 by DCS Bowed under weight
These slides bowed under the weight of a single layer of canned goods I had put on a sliding shelves in my pantry. I had to reinforce them with stock between the slides and the cabinet wall.
May 3, 2016
Rated 1.0 out of 5.0 by Beave Poor Quality drawer slides
Left and right case slides did not match in that the front rollers were 1/8 inch different vertical location. Screw did not match phillips bits so had to be replaced. In summary slides are knockoffs of a Very Poor quality that caused considerable waste of time on install.
July 22, 2016
Rated 4.0 out of 5.0 by Alee Easy to install
This item was easy to install & that quality is good for the price
July 9, 2014
Rated 2.0 out of 5.0 by Phoenix73 Not very smooth
I wouldn't buy this product again. It's installed fine but just doesn't feel that smooth, and the weight is well below the limit for this drawer slide.
January 10, 2012
Rated 5.0 out of 5.0 by mdk54 Fit perfectly
Even though my home is 15 years old I was able to find parts for the kitchen drawers that were compatible with the old.
December 6, 2011
Rated 4.0 out of 5.0 by Effy a useful and easy to install product.
It is a convenient solution for existing cabinets with fixed shelves.
July 3, 2012
Rated 1.0 out of 5.0 by Reltok Terrible design
The ball bearings on this slide are held in place by individual aluminum tabs. The first set I installed easily enough, at least until I tried to slide the drawer in, then the drawer jammed. I couldn't figure out what was wrong, until I noticed some of the ball bearings had fallen out, blocking the drawers ability to slide in. I figured I must have done something wrong and bought another set, only to have the same thing happen. Do yourself a favor and avoid these at all cost!
August 26, 2014
Rated 4.0 out of 5.0 by Homeowner replacement slides
replacement slides for a drawer. the holes don't quite line up with previous installed slides but thats an easy enough fix they seem to have a nice smooth motion
January 6, 2014