Rated 3.8 out of 5 by 50
Rated 4.0 out of 5.0 by Smitty1715 Good tool
Did a ok job A little modifying to the tool helped out a lot
June 1, 2015
Rated 5.0 out of 5.0 by Dawn install cabinet handles easily
I could not have installed my cabinet handles without this tool. You just place your handles over the holes to align and then use the square to place it on the cabinet straight and your handles are perfect every time. Best purchase. I saved lots of money doing this myself. By the way ladies, if I can do it so can you.
November 29, 2011
Rated 5.0 out of 5.0 by goodreason Must Have Template for Cabinet Hardware
The Liberty Cabinet and Drawer Pull Installation Templates are made of translucent plastic with measurement impressions embossed on it. A simple tool that makes it easy to measure for placement of kitchen/bathroom hardware. It saved time and aggravation in preventing mistakes that could have happened if each piece had to be measured.
Measure the width of the drawer panel, divide in half, place the template over the center mark, decide from the many options you have for the size of the pull or knob you're installing, to your desired height. The door template works under the same principle as the drawer template, with numerous choices of placement for your hardware.
Included with the templates is a 3/16th“ basic drill bit, more than adequate for the amount of drilling needed. Well worth the price!
April 6, 2013
Rated 5.0 out of 5.0 by TprJeff Great Product - Great Value
I purchased this kit to install knobs on a refinished bathroom vanity. Worked like charm. No guesswork involved. I would like to address the reviewer who stated that the templates would wear out after drilling through them so many times. The instructions state to simply mark the spot on to door/drawer with a pencil, remove the template and drill your hole. Nowhere does it state to drill through the templates. Used as instructed, these templates should last several years.
February 6, 2014
Rated 2.0 out of 5.0 by JB Not very useful. Too small.
the cabinet pull template is OK except for my purpose there was no hole near where I wanted to drill. So I didn't use it at all. So you need a little luck for it to line up where you want.
The drawer pull template is too small for anything over about 4". which was most of the pulls I installed. And, again, the holes didn't line up where I needed to drill. I ended up not using these at all for my installations and just used a speed square and a ruler. I wouldn't bother with these or at least be prepared to return them because they probably won't work exactly.
October 20, 2015
Rated 3.0 out of 5.0 by taomander Very helpful, but...
Wasn't always able to get this tool to work, depending upon the way the cabinet door is constructed. Only one choice of placement for the 3-3/4 in. center-to-center installation required.
February 3, 2015
Rated 4.0 out of 5.0 by caldasny It does the job
It is perfect for the job. it lines up the necessary holes on doors and drawers. It was very convenient and easy to use.
September 1, 2015
Rated 4.0 out of 5.0 by Chele Not tall enough for larger hardware
This turned out okay, but only after I measured and "made due" because it wasn't tall enough to mount my cabinet hardware where it needed to go.
I haven't used the drawer template.
August 30, 2015