Rated 4.4 out of 5 by 16
Rated 5.0 out of 5.0 by Gary Nice quality light
This light is replacing the older incandescent version, which was notorious for bad circuit boards. After replacing several of these, I found that they recalled the old circuit boards due to fire risks. These are very easy to install- it only takes 5-10 minutes.
July 22, 2016
Rated 4.0 out of 5.0 by NikaA Emergency Light for the Electrical Closet
The light was purchased for the emergency light in our electrical closet. It is not too big and not too small. I had a professional install it.
July 5, 2016
Rated 5.0 out of 5.0 by Ddehaut Looks good and works well
The light looks good it has more of a modern look than the old box type - was very easy to install (the instructions actually are easy to follow) and the fixture works well the lights are very bright.
April 5, 2016
Rated 5.0 out of 5.0 by Hcltb111 True white!
So happy to find this product at Home Depot after much searching for an actual white color. Most emergency lights we found were a cream or yellowish color and looked old.
March 22, 2016
Rated 5.0 out of 5.0 by Doc Good quality product
Very easy installation. Easy instructions and minimal effort.
January 20, 2016
Rated 3.0 out of 5.0 by HD Not bad
You need to have some knowledge of wiring as this unit can also be set up for high voltage seen in Euopean Residences.
December 29, 2015
Rated 3.0 out of 5.0 by waldeje It works
I bought this unit to shed some light on my cellar stairs and service panel when hit with a power failure to facilitate the connections to my standby generator.
On the unit itself I expected to find a a black (hot), white (neutral) and a green or copper ground. Instead, I found a black, a white and an orange sheathed wire marked 277VAC. After scratching my head a few times I realized that this orange 277VAC wire was likely a alternate hot lead used for non U.S. residential grids and just capped it. Secondly, getting the mounting knockouts out without damaging the thing was like pulling healthy teeth from a fully awake subject (not a trivial task). The instructions left much to be desired. If they were a bit more thorough they would have been a bit more helpful doing the installation. It was not obvious to me at all that the hot and neutral wires tied to the mounting plate did not have to be individually pigtailled to the unit itself so once again, I found myself scratching my head trying to figure out how the power was supposed to be tied to the battery pack/lights. I reasoned that there were two possibilities: 1- my unit was missing some wires or 2- there was a stealthy plug connection between the two that mated when the two parts were snapped together. Fortunately it was the latter rather than the former. The directions could have highlighted this fact. All in all, the unit works as advertised and it will will do the job I needed done so I would recommended it to a friend.
September 14, 2012
Rated 5.0 out of 5.0 by Kilowatt MASTER KILOWATT
The price is good and it being an LED fixture, it will last for a very long time. LED uses much less power consumption than standard lighting. As far as any difficulties in getting it mounted, such as knocking out the mounting and electrical access holes, using the proper tools and common sense will make it easy. For those who don't know, the orange wire (277VAC) is only used when the fixture is being installed in a commercial building that has a 3-phase, 277/480-volt electrical service. So you just cap off the orange wire and use the black wire for the hot wire, for a (normal) 120-volt application.
May 22, 2015