Rated 4.3 out of 5 by 28
Rated 5.0 out of 5.0 by Itshimself Great for my purposes.
First off, I am a retired Marine who likes to tinker with things, I do not use this professionally.. I have had a welder for some years and wanted a plasma cutter almost as long as I have had the welder. Great item for the price. Never used one of these before I bought it. I took it to the garages, hooked it up to the 110 v and my air compressor and it worked great cutting 1/8th inch steel tubing. Goes through sheet steel like a hot knife through butter. So easy to use for this. My technique needs work. The cutter is great. I then installed a 240 circuit for the cutter and an air drying system to my compressor and it works so much better. I have cut 1/2 inch round steel bar with this with no problem. I have been looking for a plasma cutter for some time but the cost has always been prohibitive. I have told a lot of people about this and demonstrated it and the reaction when I tell them the cost is usually entertaining. Great item for the price. I have not had it long enough to critique durability etc.
July 26, 2016
Rated 3.0 out of 5.0 by john Not consistent
I can't get this thing to work at home with a Husky 20gal compressor with 5.0scfm @40psi and 4.0scfm@90psi. It'll cut at my job but I have to mess with it for a while, anybody know what I'm doing wrong? It cuts good , when it does work
July 18, 2016
Rated 1.0 out of 5.0 by Dan Poor quality
Plasma cutter worked for less than ten minutes. Spoke with lotos rep who is giving me shipping label to return entire unit. Good costumer service.
July 19, 2016
Rated 3.0 out of 5.0 by Ron 50 Amp Dual Voltage Plasma Cutter
the price was the factor in this item , good value for a home use plasma cutter.
June 29, 2016
Rated 3.0 out of 5.0 by cppower14 Ok plasma cutter
Haven't used the cutter but one time so far. The consumables are extremely expensive and wish I would have bought the arc start model instead of the touch start torch.
July 5, 2016
Rated 5.0 out of 5.0 by RV Great product!
I have only used a couple of times but it worked great! It cut 1/4" metal with ease!!
June 7, 2016
Rated 4.0 out of 5.0 by Kevin Lotos LT5000D Plasma cutter
So far so good. Haven't used it much but from what I can see so far it dose the job. Diffently need to play around with the settings to find out what to have the amps at. The manual they send with it is very vague to say the least!!
May 24, 2016
Rated 5.0 out of 5.0 by Andrew Cuts great
Be sure to buy a lotus pigtail if you plan on using a 110 also, I can cut up to 3/8 on a 110 no problem so far easy set up
April 19, 2016