Rated 4.8 out of 5Â by 38
Rated 5 out of 5Â by JADMD No seperate wiring for your ceiling fan's light? No problem!
I recently replaced an old chandelier in the breakfast area of our kitchen with a ceiling fan that had been sitting, unopened, in the garage for 8 years. The chandelier had the basic 3 wire switch - hot, common and ground. No 4th wire to separate switch the fan and it's light.
The fan and light each had their own chain on/off controls but I didn't like to chains hanging down above the breakfast table and I wanted to be able to switch them individually from the wall as well as dim the light without affecting the fan.
Solution: the Lutron Maestro Combination Fan and Light Control. It consists of a control unit that mounts inside the fan dome as it is installed and a switch that communicates with it mounted on the wall.
Assuming that you know how to wire a ceiling fan, installation is easy. Clear instructions are included and I went to the Lutron website and downloaded a PDF version of them as well. Also, Lutron has an excellent installation video for this unit on YouTube. The video really helped this DIYer!
Functionally, there are separate on/off switches for fan and light and each of those have 7 different adjustment levels. So you get a 7 speed fan and 7 light brightness settings. Both remember the setting when switched off and restore the setting when turned back on.
The wall switch fit perfectly in the single box previously used by the chandelier switch, however the face plate was difficult to detach from the switch when unpacking it. There probably is a technique to detaching it but the instructions don't let you in on the secret.
Lutron products tend to be a little pricy and this is no exception but its a whole lot easier than running another wire from ceiling to wall switch! Also, I personally think the appearance of the wall switch is a little plain but all in all this is a great solution to ceiling fan switching!
October 4, 2013
Rated 5 out of 5Â by MercforHire This is a great product. Wooks great. Just what I wanted.
This was easy to install. Just remember to hook up the fan completely, set your speed and then install this new controller.
January 21, 2014
Rated 5 out of 5Â by Dallas123 Great purchase.
I had two installed by an electrician two years ago in the 2nd and 3rd bedrooms. There was only one wall switch and this permitted the ceiling fan and fan light to work separately at seven different levels. I recently placed three dimmable 40 Watt equivalent fan LED bulbs in one of the fans and it works fine! There is no humm from the light when is turned on or off and it dims to whatever level I wish with no problem. I previously had three CFL non-dimmable bulbs in the fan and it would humm when going on or off until it got to full light. I would highly recommend this control! When buying bulbs make sure they are dimmable or you will have a very irritating humm when the lights level is increasing to full level or decreasing to off.
December 5, 2014
Rated 5 out of 5Â by CeilingFanMan Make sure your fan motor is 1 amp or less
As other people have said, this is a great, quality, and COOL light and fan 7 speed dimmer in one. When you hit the light dimmer, it gradually increases the light from low to high (for example) over about 2-3 seconds which is a very classy effect.
I just want to add one caution. Make sure that your fan motor is either 1 amp or LESS. If your fan motor is over 1 amp, the motor will hum. Trying to diagnose ceiling fan motor "hums" are extremely annoying and waste a lot of time and resources (especially if you are hiring someone to install your ceiling fan).
Typical boxes of ceiling fans and online specifications do NOT list the level of motor amp. If you go to the store, you can ask an associate to cut open the box. On the fan motor there should be a sticker that lists various specifications, including the motor amp level. The sticker is present on Hunter brand ceiling fans for sure.
I am sharing this because I bought a hunter fan and the amp turned out to be 1.62 amp. I had to take down, return the fan, then buy another fan that had .89 amp motor. The fan does not have a hum. I hope this advice helps.
I would definitely recommend this to anyone who wants a wall switch dimmer for their fan and ceiling fan lighting. Very classy.
September 13, 2010
Rated 4 out of 5Â by Matt Good product with some hiccups
Product makes retrofitting a two wire installation into a two switch digital control for a combo ceiling light and fan. Problem I've encountered with one of the three installed is it constantly has to be reset. Sometimes the switch will indicate the light is on but it doesn't function. Or the fan will spin at a constant speed even though the switch indicates it's off. When the switches work, they're awesome but sometimes can be frustrating.
July 29, 2014