Rated 3.5 out of 5 by 15
Rated 1.0 out of 5.0 by John Junk
The fan would only work on the highest setting, otherwise the lights would flicker. I bought a more expensive switch and it worked perfectly.
May 7, 2016
Rated 4.0 out of 5.0 by Michael Works great.
Previously tried a typical dimmer switch that worked but the fan made weird noises. This works better with the three speeds as intended and no more fan noise.
December 9, 2015
Rated 5.0 out of 5.0 by sobrunsbob Saves time
easy to install, simple to operate, saves time when you have a ceiling fan that is to high to reach pull cord without standing on bed or taken out a step ladder. Just move lever to speed and flip toggle switch to turn on fan.
November 13, 2015
Rated 5.0 out of 5.0 by ranlo Wife loves it..... so do I.
Very easy to install. Instructions for either single or 3 way operation are clear and easy to understand. Contains verbiage and wiring diagrams. No more getting a step stool to set the speed in our vaulted ceiling living room. The wife can do it herself. With fan set to run on high speed, the switch gives us high, medium , and low speeds comparable to "pulling the chain". The Master bed room will be next.
May 20, 2014
Rated 4.0 out of 5.0 by Bruce Clean look.
Looks great and functions well. The speed control is a little small for my big hands. I don't know how they could make it bigger without hurting the look.
November 10, 2015
Rated 5.0 out of 5.0 by kurt love it
Great appearance, ease of use, and easy to install
May 1, 2014
Rated 3.0 out of 5.0 by ChampionGator i like it but...causes LED in fan to brighten momentarily as speeds are changed
I like this item. Just wish it worked exactly as expected. I installed it instead of a remote to go to a ceiling fan with LED light an no pull chains. I also have a Toggler dimming switch for the light from a previous install but since there are no chains on this fan I needed the fan control too (unless I wanted to use the remote and have an unused switch on the wall.) The only issue I've ran into is that as speeds are selected, when the light is dimmed, the light briefly flickers at full brightness. Seems like a slight power surge that the LED picks up that maybe a less efficient light would not.
May 31, 2015
Rated 1.0 out of 5.0 by ElectricalEngineerRon Logic is unexpected and confusing - incorrectly designed
After installing the first controller, I tested and determined it was malfunctioning, I took back to Home Depot and got another one which worked the same way. I then realized it is actually designed to work the way it does (which is ridiculous).
- "On" turns the fan on and eventually transitions to the correct speed (slow to keep the fan quiet I suppose)
- "Off" turns the fan off eventually as long as the speed slider is not touched
- Speed slider automatically turns the fan "On" even if the switch is off. This is very weird and confusing as the fan will be running in the "Off" position if someone has adjusted the speed. In this scenario, to turn the fan "Off", you have to flip the switch up and then back down again.
June 26, 2014