Rated 2.3 out of 5 by 9
Rated 3.0 out of 5.0 by Pinoypogiman Good for Lining Non-Protective Helmets
I had a Helmet (for costume/ cosplay purposes) that needed Lining/ Padding inside. and Foam Weather strip tape did quite a nice job for it.
The helmet i used is not meant for Protective use, *I DO NOT RECOMMEND YOU DO THIS FOR ACTUAL PROTECTION.
I placed the foam in a Parallel pattern inside the helmet. so now my Replica helmet fits snug.
again, this will not make your helmets safer!
The Tape/adhesive isnt strong, so you may want to apply double sided tape or glue to keep it on
August 27, 2012
Rated 2.0 out of 5.0 by Jambeau Poor QC?
1/2" is more like 3/8" - I needed the whole 1/2" - so i still have a gap for mosquitos to get into the house
June 30, 2015
Rated 2.0 out of 5.0 by DIYer Poor adhesive
The self adhesive on this product was so poor that it couldn't support the weight of itself when mounted horizontal. It would stick for a half minute then peal itself off.
May 12, 2015
Rated 1.0 out of 5.0 by davefr Won't stick to anything!!
This stuff is absolute garage simply because the self adhesive is very weak and won't stick to anything. (and yes I had a perfectly clean metal surface)
April 12, 2015
Rated 3.0 out of 5.0 by Greesmonky Worked good. 4 inches short.
Did the job I needed well. Adhesive stuck good. Some backing was hard to remove. Supposed to be 120 inches but the last 4" are unusable as they are permanently stuck to the cardboard core.
January 31, 2015
Rated 1.0 out of 5.0 by micbarton Sticky Back Hard to Remove
I found on md brands that the adhesive bonded the sticky backing so that it can not be removed without damaging the weatherstrip prior to application. I found I could use a heat gun to soften the adhesive enougth to remove it an then apply the strip - more sticky was on the white paper then then actual strip. A real pain to use. The air temp was 70 degree. I would not buy this brand again.
June 7, 2009
Rated 1.0 out of 5.0 by Kris25 Don't use!!
I have found that all foam weather srtips are difficult to work with, not removeable once you stick it down, it stays or you damage the strip to remove it, and it just doesn't last its easily damaged from just opening and closing the door or window and you have to replace it to soon.
August 11, 2010
Rated 3.0 out of 5.0 by DIY74104 self-adhesive poor
Few choices in this dept I have yet to resort to hot glueing this stuff in place - for now - I simply replace it once it no longer holds...
November 17, 2011