Rated 3.2 out of 5 by 6
Rated 2.0 out of 5.0 by donglow Glue on Wrong side
Complete agree with the reviewer who said the glue was on the wrong side. It would have worked so much better to glue it to the metal panel and then position the metal panel correctly. It is very hard to put metal roofing on a steep roof, by yourself, to began with. After fiddling with this, trying to line them up correctly so the my next metal panel fit properly, I decided they were worth the extra difficulty and increase in life threatening falls. They are in the garbage!
October 16, 2016
Rated 5.0 out of 5.0 by RickB perfect for sealing.
did its job. easy to install. had a strip of glue already on it.
October 11, 2016
Rated 3.0 out of 5.0 by ptk Not so good
This ribs did not match with the panel groves exactly. I had to cut about 1 inch piece regularly to fit in to the groves in the panel
October 11, 2016
Rated 1.0 out of 5.0 by Josh Get it somewhere else
No glue on the ends. Melted to bottom of box, customer service thought it was funny,
Customer service is horrible.
August 3, 2016
Rated 5.0 out of 5.0 by Bruce Patio cover closure strip
Use this to close the ends of metal roofing panels for a patio cover.
July 5, 2016
Rated 3.0 out of 5.0 by Bigriver Used for interior metal siding in work shop.
The closure material has the glue on the wall side. That is fine you can get it stuck on the building in the right position to match the ribs. Would be much easier if the closure material was configured such that you could glue it to the metal siding before the siding is installed. That's why I gave it 3 stars.
February 16, 2016