Rated 3.2 out of 5 by 43
Rated 1.0 out of 5.0 by la1st ge GFI 50 amp
don't buy GE products just like this one had to replace it and put in squre d brand
July 23, 2016
Rated 1.0 out of 5.0 by calebv DOA
Spent a bunch of time trying to figure out why the GFCI kept instantly tripping. I bought it for a used hot tub I picked up and thought there was something wrong with the hot tub. Nope. Broken from the factory.
July 12, 2016
Rated 1.0 out of 5.0 by CLINCHMNTN 50 amp midwest spa breaker box with GE GFI
pure junk home depot should not be selling this product. breaker never would work.would have been a good deal if it wasn't junk. you get what you pay for.
April 26, 2016
Rated 4.0 out of 5.0 by Prism Good value but be aware no rear knockout.
In my experience this is a very good value, the breaker alone from my supply house was more expensive than this whole set up. However, there is no rear knock out in this box which was quite a surprise. There is room to create one and I really think they should it would be off center but something would be better than nothing. There is a top access point but that will require a hub and water tight connector to be used. I think a simple pictorial wiring pattern would be helpful or open prior to installing and familiarize yourself. There is a line diagram but I found it to be small print an less intuitive. Again, tho over all a good solution.
May 12, 2015
Rated 2.0 out of 5.0 by Handygirl1955 Very Short Lived 60 amp GFCI breaker
I do not see the Midwest 60 AMP GFCI Spa Panel on the web site but our local Home Depot carries it in stock and our spa requires the 60 amp. After being installed for 15 months, the breaker failed- which in return caused out spa to freeze- causing several hundred dollars worth of damage. We just purchased another one of this brand since it is the only one available without special order in our area. We are hoping to get more than 1 year out of this one but if not, we will let the spa sit unused until we can get another brand ordered. VERY DISSAPOINTED CUSTOMER on this. Hopefully our other electrical panels / breakers hold up... they are ALL GE.......
May 22, 2015
Rated 1.0 out of 5.0 by Disappointed JUNK!!!!!!!!!Can't find a hub unless special order and all reviews for both 50 and 60 amp disconnects say GFI breaker is defective
Simply JUNK, can"t find a hub for it at HD or local supply house and all reviews say breaker is garbage" " just wait till someone gets killed cause GFI doesn"t trip then they will figure it out
December 18, 2015
Rated 5.0 out of 5.0 by Zooey works perfect for me
I live in Florida and installed this with #8 stranded copper wire. Make sure you wind your copper end connections tightly w/o breaking/cutting ANY strands! All connections need to be TIGHTLY SECURED! Once these instructions are followed, you should have a flawless performance for less than half the price of a Square D box and 50 amp gfci..no brainer! I have used this for over a month no w/o any problem..it trips/resets perfectly.
November 7, 2015
Rated 1.0 out of 5.0 by KMac I should have read the reviews before purchasing.
I purchased this spa panel to install a hot tub at home. The entire package cost less than a stand alone 50 amp GFCI breaker. I figure that with the breaker being a GE, it would be a good value. WRONG...
A long story, really shortened... The breaker worked for about 30-45 minutes, then--- POP..
Of course, I had to check everything associated with the install. Each conductor.. Ground, neutral.. Hot tub terminals, control panel, etc.. It was the GFCI breaker. I had to remove the panel and return it. I kept the mounting hardware to ensure I wouldn't have to put "new" mounting holes in my home. I am glad I did, there was NO mounting hardware in the box...
After reading these reviews, I have no faith that it will last..
August 17, 2015