Rated 4.1 out of 5 by 12
Rated 2.0 out of 5.0 by JoeGunn Bit broke with moderate use.
Handy little bit, but only lasted about 4 months of regular use. The bit snapped it off tightening a bolt under relatively light torque.
January 8, 2016
Rated 4.0 out of 5.0 by RRman Good 1/4 in. to 3/8 Socket Adapter
This socket adapter lets you use your 1/4 drive drill, with your 3/8 drive sockets.
June 21, 2016
Rated 5.0 out of 5.0 by Woody59 Does what it is supposed to.
Does what it is supposed to. It seems to be of good quality at this point.
June 9, 2016
Rated 5.0 out of 5.0 by lilrabbit Does the job
This is one of those little "get at it" tools that always seems to be missing when you need it, so you buy three or four and can't find any of them...until you buy another one.
Anyway, I've been using this one for a year and haven't lost or broken it yet. It's convenient to be able to use my cordless impact driver as a socket wrench, especially for things like driving lag screws.
Hint: put a little oil on those six inch lags before you drive them into a railroad tie. This will make your driver last a lot longer and also allow you to get more screws driven on a single charge of the battery.
August 23, 2015
Rated 1.0 out of 5.0 by Stodd Cheap...
Cheap. Ball and spring already came out. Used once
October 27, 2015
Rated 5.0 out of 5.0 by cmill Very helpful
You need this if you are using sockets with an impact driver. Have not had any problems so far, and seems to be built well. Fits nice with my Ridgid impact drill, but I have seen these sold in a three pack with the other two sizes. Buying these separately is a bit more expensive.
June 22, 2015
Rated 4.0 out of 5.0 by RednexToyz Adapts my Drill/Driver to Sockets
Allows me to use my standard & deep 3/8" drive sockets with my cordless drill/driver unit. Holds up well. Retains the sockets with a ball detente that has a good amount of force to keep the sockets from falling off during use.
March 2, 2015
Rated 5.0 out of 5.0 by Doresoom Works Great!
This socket adapter is super easy to use, especially in conjunction with the new Milwaukee M12 Fuel Impact Driver.
Just pull the collar out and slide the adapter in. Then press on whatever socket you're going to use. The ball detent keeps it in place very well, but releases the socket with a reasonable amount of force when you want to change it out.
It doesn't mention it on the website, but the packaging in store specifically states it's rated for use with impact drivers.
January 21, 2013