Rated 4.1 out of 5 by 248
Rated 5.0 out of 5.0 by DJH Good product.
I needed a hole saw to handle several types of material all in the same cut. Cut through steel, then wood then plastic without hesitation and with little feed pressure. Connects to my existing Milwaukee spindle with no issues. I will likely buy more sizes based on my experience.
October 4, 2016
Rated 4.0 out of 5.0 by JJH1989 Second time is the charm.
This is the second of these that I purchased within a one year time frame. I was using the product on a Delta Drill press when the first one began to dull while cutting through 3/4" pine boards after only cutting 12 holes and not in succession. I noticed that the hole saw had minor cracks on the side of it so I stopped. I replaced it with a new one and have, since cut 16 holes with out a problem. I would recommend this product to both Beginner and pro.
July 15, 2016
Rated 5.0 out of 5.0 by Murph Great hole saw
Had to cut metal and 3/4" plywood behind it. The bit got hot as hadees, but kept cutting without dulling. Made several holes and the bit is as Sharp az when I opened package. Great hole saw!
February 16, 2016
Rated 5.0 out of 5.0 by Nebulator Perfect for the job
Cut through my soffit to put a bathroom vent in perfectly
October 18, 2016
Rated 5.0 out of 5.0 by AB9981 Awsome tool
I needed to cut a hole in a steel "I" beam. Amazingly, it cut through it with no trouble.
October 11, 2016
Rated 5.0 out of 5.0 by Richard Does the job if you keep it cool
I see a number of reviews criticize this saw because it dulled on them in both wood or metal. I too have ruined some of these hole saws in the past by not keeping them cool while sawing the hole. Use lots of oil or soapy water in a spray bottle to cool the teeth as you are drilling and the saw teeth will retain their temper and saw efficiently. This one worked great to cut a taillight hole in jeep CJ body armor .
September 28, 2016
Rated 1.0 out of 5.0 by EJ No hole
Did not even go thru corrugated wall once before teeth wore off, maybe it was a defect
October 4, 2016
Rated 4.0 out of 5.0 by Retired Worked in less than ideal situation
The hole saw worked well in some extremely "sappy" cedar from a tree recently cut down. It loaded up with sap every so often. So, I just kept a bucket of warm water with dish detergent in it nearby and would dunk the hole saw in that from time to time. I drilled four fairly deep holes with it.
June 16, 2015