Rated 4.3 out of 5 by 98
Rated 4.0 out of 5.0 by DS Nice Nailer
Works very well. No jam's so far. Good price and fast shipping
October 11, 2016
Rated 4.0 out of 5.0 by Bill9 1st air nailer
Has touchy trigger driving two nails at a time occasionally, but for the price a great deal
October 18, 2016
Rated 5.0 out of 5.0 by Rick Good Deal / Best Value
Ok so this works great the price cant be beat and its over all quality is great heres the drawbacks its only uses 16 gauge strip nails and it seems to leave a somewhat larger hole when driving the head beneath the surface I recommend only driving the head flush with the wood, Its Solid I dont think it will break it does one thing really well.
August 8, 2016
Rated 4.0 out of 5.0 by Homeowner Solid nailer at good price
Got this for chair railing and crown molding. It was a good price and has worked perfectly. The only thing I don't like is that the nailer does require oiling occasionally.
September 13, 2016
Rated 4.0 out of 5.0 by Nailer37 Finish nailer
Works well for my small projects. But I can't seam to find 16 gauge nails.
August 17, 2016
Rated 5.0 out of 5.0 by Rooter works as advertised
So far I have only shot about 200 nails but there have been no jams, etc. The nails have been 1 and 2 inch a were driven into poplar and pine. A small change in air pressure is all that was needed to properly seat the nails. It performs as reliably as my Senco framer but at a much better price point.
July 19, 2016
Rated 5.0 out of 5.0 by Senior Great Product
This nailer is just what I needed. I had an older nailer which required a re-build kit which actually cost more than my new nailer. Received it on time and used it immediately. Couldn't be happier
July 12, 2016
Rated 4.0 out of 5.0 by SteveP Solid construction, good value.
This has been a sturdy, solidly built tool so far. I am using it to install new trim and casings throughout the house. Having used a variety of other air powered brad, staple and nail drivers, I found the "Single Sequence Mode" firing system awkward at first. The instructions mention this firing style, but fail to articulate fully how this mode works. Essentially you have to make sure to completely lift the nailer off the work piece and release the trigger before it will finish cycling and load for the next shot. It has been running smoothly without any jamming despite being fed a variety of fastener brands and sizes. A solid tool so far.
December 6, 2012