Rated 3.5 out of 5 by 15
Rated 4.0 out of 5.0 by screaser Pretty good solution to cold water at sink problem. With restricted electricity supply.
I did not install this personally, but a plumber did as part of a remodel. That said, i don't believe this is hard to install, even i might do it and i hate plumbing!
This was installed on a cold water line (in Texas) during February for a kitchen faucet. It has been cold, ie. the water is going to be cold too, and the water has been the right temperature for washing dishes. No need to cool the water with the cold tap, and in fact this *won't work* because if you turn on the cold tap in a "mixer" arrangement as we have the back pressure from the cold tap swamps the hot pressure and the water heater shuts down.
The flow is perfectly adequate for a smaller sink, maybe a bit low for the large sink i have. I would have bought a higher flow model but was restricted to a 30amp model as a larger one would have necessitated a $500 charge to an electrician to run a new wire (not economic sense for a $150 water heater).
Was considering attaching to the hot water line (the distance from the tank is so great the water was cold when it *eventually* got there) but this is expressly forbidden in the instructions. Makes sense as there is no heater cut-off when the incoming water gets too hot (why? The higher rate models do, is it because they cost more?). If i ran a sink-full of water then the hot water from my tank would have reached the heater and caused a problem. Best to avoid that.
Anyway, i am happy with the product. We've had it running a month and once we figured out about not running the cold tap at the same time we haven't had any problems with it and our dishes are clean.
March 15, 2016
Rated 5.0 out of 5.0 by Fisherman Tankless Electric Water Heater
The water heater is easy to hook up to plumbing supply lines. You will need to have the correct size wiring and plug for the 240 volt power supply. Works fine for a single sink that we use at our camp.
August 24, 2015
Rated 4.0 out of 5.0 by efk1961 Good point of use water heater
Needed to have hot water in the tack room of my horse barn. For years there was a 30 gal electric hot water tank. When the tank started to leak I decided to try a tank less heater. This one looked like it would do the trick. The 7.2 kw 240 Volt Point-of-Use Tank less Electric Water Heater works well. The installation was easy, and quick. You can see the switch working as the water is turned on, (if you are curious and check it with the cover off.) I was concerned about low flow from my well but it still worked well. Hot water in 10 seconds. Probably will pay for itself in saved electric. Or I would have been saving for years if I did this sooner.
July 9, 2013
Rated 2.0 out of 5.0 by DarrylC Does what it's supposed to do...
Installation was a breeze. The unit is fairly compact and can be located just about anywhere. It allows for horizontal or vertical mounting. This was purchased to supply hot water to 2 small back-to-back sinks. The hot water it produces is barely hot. It's good enough for its intended use, but you can't expect it to supply sufficient hot water to a shower, washing machine or dishwasher. You'll need to look at higher output models for those types of applications. Plus, if both sinks are turned on at once, flow is cut in half. Knowing what I know now, I would not recommend this unit, as it just does not produce enough hot water.
May 29, 2012
Rated 1.0 out of 5.0 by DaveZ Junk
DO NOT BUY THIS PRODUCT. After professional installation, we had to reset the internal circuit breaker after every few uses. Then it would just stop working altogether. Then start working again. When it did work the temperature was totally inconsistent no matter how much we varied the temperature setting and flow rates. We called Bosh and were told to contact their local service representative. He came out but told us he only worked on gas heaters. Bosh's warranty required us to pay for an electrician to come out. But now, on top of everything else, the unit leaks. JUNK! Don't waste your money!
May 21, 2014
Rated 2.0 out of 5.0 by Pressure Restricted
Put this in for a sink in my shop, there is 100psi going in the heater and about 1psi coming out. It definitely makes the water hot but there is no pressure what so ever. I thought it was clogged somehow but it is actually restricted internally to a 1/8". If it had more flow it would be great as it heats the amount of water coming out great. Enough so that you could have more flow and it would probably still be scolding hot. Disappointed that I couldn't adjust to get more pressure out. Took it back and am looking for a different heater now. It is the ae7.2 that I had
April 23, 2013
Rated 4.0 out of 5.0 by Butch Very Satisfied
So far this point of use tankless water heater has operated very good. My house has one bathroom operating off one water heater while the other bathroom, kichen and laundry have their own water heater. When the water heater to the individual bathroom went out I decided to try a small tankless so I would not have to do any electrical work. I installed it myself and it is operating the sink and shower just fine. Won't know if it will work when temps get cooler but for now am very satisfied.
July 17, 2012
Rated 4.0 out of 5.0 by rtfr The only problem I found with this item is if the water in is turned off while the unit is pluged in.
Not hard to hook into the water supply just be sure to use a flex hose on the in side and put hot water pipe on the out side. Once hooked up any time the hot side is turned on the unit is on and is heating the water. Depending on the flow of water the hotter it gets.
December 17, 2013